BOTTOM TRAY
(1)
5/16 X 1.25
KNOB (2)
3-CCH-12
SEE DETAIL A
DETAIL A
SCALE 0.200
SHELF BRACKET
(4)
3-CCH-6
1/4" LOCK
WASHER (8)
1/4" X 1/2" LONG
BUTTON HEAD SCREW
(8)
CART AXLE
(1)
3-CCH-10
CART WHEEL
(2)
3-CCH-11
1/2" FLAT WASHER
(1)
AXLE COTTER PIN
(1)
COTTPIN
Step 1: Turn stove upside down with front facing forward. Slide the cart axle
through one wheel and cart legs. Attach the remaining wheel and the 1/2”
flat washer. Secure the cart axle with the axle cotter pin. (See Figure 1)
Step 2: Stand stove upright. Attach bottom tray as shown. (Figure 2) NOTE: Legs
should be pressed out to put pressure on legs when tightening knobs.
Step 3: Attach shelf brackets by aligning the bracket on the cart legs and inserting
the lock washer and button head screw. (See Figure 3)
Step 4: Attach regulator hose to mip. Tighten using wrench. Perform soap and
water test to check for leaks.
Step 5: Assemble side shelves by inserting hook over the bottom rod in the
brackets assembled in step 3. Lift shelf up and rotate into upper rod.
Press shelf down to lock into position.
Figure 1
Figure 2
Figure 3
Figure 4
SETUP INSTRUCTIONS
CART SHELF
(2)
3-CCH-5
LP REGULATOR
(1)
3-0835
Figure 5
Folding Legs: When collapsing the legs ensure that the legs without wheels fold
first. When both sets of legs are folded, use the included bolt to secure the leg to
the cart. (See Figure 5)
0411-CCH4-Instructions
/
