11
1
YOUR VEHICLE AT A GLANCE
Snow Wiper
The snow wipers and windshield washer are
controlled by the lever designed on right side of
steering wheel providing that the switch is OPEN.
0- OFF
1- Intermittent snow wiper* (The interval between
two movements of snow wiper is dependent on the
vehicle’s speed.)
2- Low speed
3- High speed
Single-step wiping (just one cycle)
For just one movement of snow wiper, pull the
lever downwards just once and then release it.
By holding the lever downwards, the snow wiper
will move continuously.
Windshield Washing
In order to wash the windshield, pull the lever
towards yourself. By pulling the lever once,
the snow wipers will move three times, as
long as you hold the lever, the windshield
washer will keep on functioning.
By pulling the lever, the water spraying
will be started, and after water spraying,
the snow wipers will start to move for 0.7
second. As long as you hold the lever, the
function of water spraying and washing will
keep on without any stop, but immediately
after releasing the lever, the snow wipers
will stop after three moves. At most after
3 seconds from stop, the complementary
fourth movement of snow wiper for cleaning
the windshield completely will function.*
*If installed on your vehicle
Warning
In time of freezing, ensure the snow wiper blades are not frozen. (Risk of overheating of snow wiper motor.)
Check the status of blades. When the blades performance is weak, you shall replace them. (approximately
once a year.)
Clean the front windshield regularly, In case you turn off the vehicle engine before turning off the motor of
snow wiper (Mode 0), the wiper blades will stop in their current position.
After powering on the vehicle engine, it is enough to set the snow wiper lever in 0 mode, to return the wiper
blades in STOP position.
When you want to open the engine hood, please ensure that the snow wiper blade is in 0 mode (STOP).
(Risk of injury).