Livex Lighting 73952-07 Installation guide

Brand: Livex Lighting

Model: 73952-07

Type: Installation guide

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT#73951 73952

For Ceiling Mount Fixtures

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

MOUNTING THE FIXTURE

1. Shut off the power at the fuse box or circuit breaker box.

Remove the old fixture from ceiling, including the single

bar.

2. Carefully unpack your new fixture and lay out all the parts

on a clear area. Take care not to lose any small parts

necessary for installation.

3. Thread the two mounting screws about 1/4”into the

pre-drilled holes in the single bar spaced the same distance

apart as the holes in the pan (A).

4. Attach the single bar to the Junction Box using the two

screws from the Junction Box. The side of the single bar

marked "GND" must face out.

5. Hold the pan (A) towards the single bar and connect the

electrical wires as follows (See Fig.2). Connect the black

wire from the fixture to the black house (hot) wire; connect

the white wire from the fixture to the white house (neutral)

wire. Make sure all wire nuts are secured. You may wrap

the connections with electrical tape. If your Junction box

has a ground wire (green or bare copper) connects fixture’s

ground wire to it. Otherwise attach the bare copper fixture

wire to the green ground screw on the single bar. Tuck the

wire connections neatly into the ceiling junction box as you

are holding the fixture assembly toward the ceiling.

6. Finish mounting the pan (A) by placing it over both

mounting screws so that the screws protrude from the

keyholes in the bottom of the pan (A). Rotate the pan (A)

until the screw are seat in the slots of the keyholes and

tighten it with a screwdriver.

7. Install the light bulbs in accordance with the fixture’s

specifications.

DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

8. Attach the glass shade(B) to the big ring(D), raise the

assembly to the pan , aligning the thread hole of pan with

the ring's hole, then tighten it with the screws(C).

Your installation is now complete. Return power to the

junction box and test the fixture.

Fig.1

screw

Fig.2

MIN 90℃ SUPPLY CONDUCTORS

DOC20150973951

White or

HOUSE

Black

WIRES

(Hot)

Smooth

FIXTURE

WIRES

Black or

Ribbed

WIRES

FIXTURE

Bare Copper(Ground)

FIXTURE

WIRES

Copper

(Ground)

HOUSE

(Neutral)

WIRES

White

Bare

Green or

WIRES

HOUSE

Livex Lighting 73952-07 Installation guide

Livex Lighting 73952-07 Installation guide

Livex Lighting 73952-07 Installation guide

Related papers

Other documents