309/3715
3
3
Issue 2: 05/ 1 1/12
nuts
Please open all 3 boxes before commencing assembly of the set.
This box contains 1 table leg, 2 chairs and 2 pillows.
339/3642
3
•
S afety and Care Advice
Important – Pl e a se read the se instructions fully be fore starting asse mbly
• Check you have all the
components and tools listed on
pages 2.
plastic bags and separate them
into their groups.
• Keep child ren and animals
away from the work area, small
parts could choke if swallowed.
• Make su re you have enough
space to layout the parts before
starting.
• Do not stand or put weight on the
product during assembly, this could
cause damage.
• Assemble the item as close
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
chair or your floor.
• Parts of the assembly will be
easier with 2 people.
• We do not
recommend the
use of power
drill/drivers for
inserting screws ,
as this could damage the unit.
Only use hand screwdrivers.
• Dispose of all packaging
ca efully and responsibly.
Care and mainte nance
• Only clean using a damp cloth
and mild detergent, do not use
bleach or abrasive cleaners.
r
the e are no loose nuts on
• F om time to time check that
r
this chair.
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal centre.
• Make sure each studs
matches the corresponding
figure to ensure correct
assembly.
• Assemble all parts and nuts
loosely during assembly,only
once the product is complete
should you fully tighten the
nuts.
• Maximum safe seated
weight: 110kgs.
The quantities below are the correct amount to complete the assembly.In some cases more
fittings may be supplied than are required.
1
2
3
4
5
6
C
Tools required
Stud x 9
Washer x 9
Nut x 9
6X1.0
M6
M6x45
3
A s s e m b l y I n s t r u c t i o n s
Use stud ,washer ,
and
nut to fix the seat
panel to back panel
by wrench.
C
2
4
C
2
4
Use stud ,washer ,
and
nut to fix the left
panel and right panel
to back panel by
wrench.
C
1
3
2
C
3
1
2
Right
Do not fully tighten
nuts at this stage.
Do not fully tighten
nuts at this stage.
3
nuts
Assembly Instructions
and cushion
chair
5
6
5
6
After all the parts are positioned, you can now fully
tighten all nuts fixed on previous steps.
nuts
/
