Lucent Technologies CIB 2864 Quick start guide

Category
Telephones
Type
Quick start guide
CIB 2864
Hands-Free Unit
CIB 2864
Comcode 103-974-580
Issue 2
CIB 2864
Hands-Free Unit
Operation of the Hands-Free Unit (HFU) or speakerphone makes it pos-
sible to place and answer both outside and intercom calls without using
the handset of the associated voice terminal. The HFU can only be used
with 10- and 34-Button Voice Terminals.
INSTALLATION INSTRUCTIONS
1
Place the HFU on the desk or table near the voice terminal to which it
will be connected.
2
Using the D8AC Cord supplied with the HFU, connect one end to the
rear of the HFU; remove the protective label covering the “OTHER”
jack and connect the opposite end to the “OTHER” jack on the bot-
tom of the voice terminal (see Figure 1).
‘LINE’
JACK
‘OTHER’
JACK
TO CONTROL UNIT
MODULAR TERMINAL
CORD (D8W)
D8AC
CORD
10-BUTTON VOICE
TERMINAL
(BOTTOM VIEW)
VOLUME
CONTROL
HANDS-FREE UNIT
FIGURE 1
iss 2, cib2864-1
OPERATING INSTRUCTIONS
1
Leave the handset on the voice terminal.
2
Press the SPEAKERPHONE ON/OFF button. The speakerphone
and microphone lights come on (see Figure 2) and you will hear dial
tone.
3
Dial the number if placing a call.
4
Begin your conversation.
5
Slide the Volume Control lever for a comfortable listening level (see
Figure 2).
SPEAKERPHONE
LIGHT
VOLUME
MICROPHONE
CONTROL
LIGHT
FIGURE 2
Deactivating Microphone
1
Press the MICROPHONE ON/OFF button. This will prevent the other
party from hearing conversation at your end of the call. The micro-
phone light goes off.
2
Press the MICROPHONE ON/OFF button when you again wish to
converse with the other party. The microphone light comes on.
Terminating the Call
1
Press the SPEAKERPHONE ON/OFF button.
2
The speakerphone and microphone lights go off.
iss 2, cib2864-2
  • Page 1 1
  • Page 2 2
  • Page 3 3

Lucent Technologies CIB 2864 Quick start guide

Category
Telephones
Type
Quick start guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI