IBM E12 User manual

E12
IBM
Brand
IBM
Model
E12
Type
User manual

This manual is also suitable for

8271 N
WAYS
E
THERNET
LAN S
WITCH
M
ODELS
E12
AND
E24
Q
UICK
I
NSTALLATION
G
UIDE
Package Contents
Quick Reference Guide
Version 2.0
User’s Guide
Quick Installation
Guide
CD-ROM
8271 Model E12 (02L0876)
8271 Model E24 (02L0877)
Release Notes
4 x rubber feet
2 x mounting brackets and 6 x fixing
TCVR
green
flashinggreen
off
= enabled,linkOK
= disabled,linkOK
= linkfail
Status
Module
Unit
10BASE-T/100BASE-TX
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
1
1
2
2
3
5
1
4
7
6
8
2
13
13
14
14
15
15
16
16
17
17
18
18
19
19
20
20
21
21
22
22
23
23
24
24
25 26 PacketPacket
Packet
25 26 Status
Status
Status
Power/Self test
6x 7x
18x 19x
1x
13x
25x 26x
12x
24x
Management
Guide
Installing the Switch
DANGER: SD21-0030.
The User’s Guide also contains further information
on the following steps.
Installing into a 19-inch Rack
Fit the brackets as shown in the figure below to
each side of the unit. Following the manufacturer’s
instructions, secure the unit into the rack.
You must use the screws supplied with the mount-
ing brackets. Damage caused to the unit by using
incorrect screws will invalidate your warranty.
Powering-up the Switch
1
Plug the power cord into the power socket at the rear of
the Switch.
2
Plug the other end of the power cord into your power
outlet.
DANGER:
It is essential that the mains socket
outlet is installed near to the unit and is accessi-
ble. You can only disconnect the unit by removing
the appliance coupler from the unit.
The Switch powers-up and runs through its Power
On Self Test (POST), which takes approximately 12
seconds. When the POST is complete, check the
Power/Self Test LED to see that your Switch is oper-
ating correctly.
Further Information
■
You can find further information about installing
and powering-up the Switch in the
“IBM 8271
Nways Ethernet LAN Switch Model E12 and E24
User’s Guide”
.
■
For information about setting up the Switch for
management, refer to Chapter 2 of the IBM Nways
Ethernet LAN Switch Management Guide.
Color State
Green The Switch is powered-up and operating normally.
Yellow The Switch has failed its POST.
Off The Switch is not receiving power.
Part Number: 35L2182
Published: January, 1999
  • Page 1 1
  • Page 2 2

IBM E12 User manual

E12
IBM
Brand
IBM
Model
E12
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents