2. ML Accessories
  3. LFCONIP2FX

ML Accessories LFCONIP2FX, LFCONIP2SS, LFCONIP2WS, LFCONIP4FX User manual

  • Hello! I've reviewed the Installation and Maintenance Manual for the LED strip LFCxx. This manual outlines the necessary steps for setup, including securing the LED flex and applying glue. I'm ready to assist you with any questions you might have about the contents of this document or the installation process.
  • What is the first step for installing the LED strip?
    How should the LED flex be inserted into the connector?
    What should be done after adding glue to the connector?
    How long should the cap be left on the connector to dry?
INSTALLATION & MAINTENANCE MANUAL
LFCxx
• Peel off the 3M tape from the back of the LED strip
• Open the connector
• Insert the LED flex with the chips facing up and the connector facing down. Lock the
connector onto the LED flex. Insert LED flex or supply cable into the other side and repeat
the process
1. Peel off the 3M tape from the
back of the LED strip
• Peel off the 3M tape from the back of the LED strip
• Open the connector
• Insert the LED flex with the chips facing up and the connector facing down. Lock the
connector onto the LED flex. Insert LED flex or supply cable into the other side and repeat
the process
2. Open the connector
3. Insert the LED flex with the chips facing up and the connector facing down. Lock the
connector onto the LED flex. Insert LED flex or supply cable into the other side and
repeat the process
• Peel off the 3M tape from the back of the LED strip
• Open the connector
• Insert the LED flex with the chips facing up and the connector facing down. Lock the
connector onto the LED flex. Insert LED flex or supply cable into the other side and repeat
the process
• Peel off the 3M tape from the back of the LED strip
• Open the connector
• Insert the LED flex with the chips facing up and the connector facing down. Lock the
connector onto the LED flex. Insert LED flex or supply cable into the other side and repeat
the process
• Add the glue into the hole of the connector until it starts to overflow. Wipe away any excess
glue
• Cover the hole with the cap and allow to dry for 10 minutes before handling
4. Add the glue into the hole of the
connector until it starts to over
flow. Wipe away any excess glue
• Add the glue into the hole of the connector until it starts to overflow. Wipe away any excess
glue
• Cover the hole with the cap and allow to dry for 10 minutes before handling
5. Cover the hole with the cap and
allow to dry for 10 minutes before
handling
AVSEP21_V1
ML Accessories Limited LU5 4LT
www.mlaccessories.co.uk
02
INTERNATIONAL
CONTACT DETAILS
INTERNATIONAL
CONTACT DETAILS
INTERNATIONAL
CONTACT DETAILS
/