2. Classic Exhibits
  3. TF-402

Classic Exhibits TF-402 Setup Instructions

  • Hello! I have reviewed the user manual for the TF-402 Aero Table Top Sign Kit #3. This document provides clear, step-by-step instructions for assembling the kit, which uses a simple push-button connector system. It also includes notes on cleaning, packing, and attaching graphics. I'm ready to answer any specific questions you might have about the assembly process or the kit's features.
  • Are any tools required for assembly?
    How do I clean the aluminum extrusion or acrylic inserts?
    How do you make push-button connection?
www.classicexhibits.com
Step 1
Page 1 of 2
866.652.2100
© 2008
Order #XXXXX — TF-402 - Aero Table Top Sign Kit #3
NOTE :
PDF copies of your Setup Instructions are available @ www.classicexhibits.com
Use the Search Tool located on the lower left-hand corner of the Classic Home page.
Enter your 5-7 digit Order #. Search for Setup Instructions
search
Note: Attaching Graphics
Attach Graphic to Velcro by wrapping
the Graphic over the Top of the Upper Horizontal
and under the Bottom of the Lower Horizontal
Plan View Front View
2
4
1
1
3
2
6
5
Steps:
1) Attach Base Plates 1 and 2 to verticals
1 and 2 as shown.
2) Assemble pieces 3 thru 6 together
as shown.
** Occasionally spraying a silicon lubricant to the metal connections will make assembly easier.
Using Your Setup Instructions
The Aero TableTop Setup Instructions are created specifically for your configuration.
They include an exploded view of the frame which is sequentially numbered. We encourage
you to study the instructions before attempting to assemble your exhibit.
Push-button connectors and pre-connected horizontal sections make assembly very simple.
No tools are required.
Cleaning and Packing Your Display
1) Use care when cleaning aluminum extrusion or acrylic inserts. Use only non-abrasive cleaners.
2) Retain all packing material. It will make re-packing much easier and will reduce the likelihood of
shipping damage.
Connections are made by holding the button
down and sliding the red tube into the opposing tube
until it locks in place.
To disassemble, push button and pull or twist extrusions apart.
Push-Button
Push-Button
6 6
6
6
Numbered Label
Table Top Base Plate Connections
Push-Button
Base Plate Connections are made by holding the button down and sliding the red
tube into the opposing tube on base until it locks in place.
6
6
Base Plate
Frame
Frame
Base Plate
/