RADSON MUNA E T - MOUNTING Owner's manual

Brand: RADSON

Model: MUNA E T - MOUNTING

Category: Alarm clocks

Type: Owner's manual

This manual is also suitable for

MUNA E T

RADSON MUNA E T - MOUNTING gives you the possibility to mount your towel dryer to a wall. This allows you to save floor space and get towels dry faster. The mounting set includes all the necessary hardware, making the installation easy and convenient.

Muna E T



















     

[kg] [watt]

 905 500 438 960 620 16,60 500

 1205 500 438 1260 990 21,50 750

 1655 500 438 1710 1460 28,20 1000

 1730 600 538 1785 1460 35,00 1250

 1730 800 738 1785 1460 36,90 1500

stock Radson





 = height - hauteur - hoogte

 = lenght - longueur - lengte

= spacing HORIZ brackets - entraxe xations HORI - hartafstand bevestigingen HORI

 = height, including control box - hauteur, boîtier inclus - hoogte, bedieningsdoos inbegrepen

 = spacing VERTIC brackets - entraxe xations VERTI - hartafstand bevestigingen VERTI

126 - 138

74 - 84

150

mini

300













    

classe II - IP44 - IK 09 - CAT C

ELECTRICITE

performance

(en cours

d’obtention)













1. Filter cleaning indicator light.

2. Blower operation indicator light.

3. Appliance operation indicator light.

4. Infrared receiver cell.

5. Appliance on/standby



Press the button

located on the side of the blower to switch on

the appliance (blower and appliance).

• Indicator light: Solid green - Turbo + appliance switched on.

• Filter 1 indicator light: Off.



• Off: Switched off.

• Solid green: Switched on.

• Flashing red: Working.





In the case of overheating caused by the presence of towels

or any other obstacle obstructing the blower’s air outlet

too much, the appliance’s operation is stopped (red/green

ashing of indicator lights 2 and 3). The blower’s operation

restarts when the temperature drops again, for the rest of

the pre-programmed time.



In case of overheating on the blower’s element, a thermal

safety with manual reset mechanically cuts off the blowing

function.



• Filter 1 indicator light: Flashing red.

• Blower indicator light: Solid green.

 Clogging up of the lter can lead to this

overheating. Clean it if necessary.

Press the button “on / standby”

for more than 6 seconds

to clear this alarm.

 Ensure you clean the lter each time the lter cleaning

alarm is triggered (see “Filter cleaning”).

 If the cause of overheating is not identied, the

alarm will be triggered again. In this case, contact your

installer as without intervention, this may, over time,

damage the blower.



The FM radio infrared emitter can

send a blower Turbo start-up order

during a time adjustable by 10

minute intervals which can go up

to 2 hours (the factory congu-

ration dened by default sets the

Boost time at 30 minutes).

Select the mode required by successively pressing the Boost

button. (available in





Auto





,



mode (cf FM radio infrared

room thermostat notice)).

Boost

: Appliance boost only (Indicator light 3:

Flashing red).

Boost Blower boost only (Indicator light 2:

Flashing red).

Boost

Appliance + blower boost (indicator lights 2 and 3:

Flashing red).

The display of the Boost time countdown replaces that of

the time.

To change the Boost duration, press the +/- buttons: the

adjustment is done in steps of 10 minutes.

 You can stop the forced operating at any time

by pressing the Boost button until the Boost segment

disappears.

  









The blower Turbo is equipped with an anti-dust lter which when saturated, can

cause the blower to stop (see “Thermal safety”).

The lter’s indicator light 1 lights up in solid red at the end of 200 hours use. In this

case the blower function becomes inoperable. The lter should then be cleaned.

The blower indicator light remains solid green whatever the orders emitted by the

timer of the FM radio infrared emitter.

 The appliance must remain switched on to allow deletion of the lter

cleaning alarm



3. Clean your lter using a vacuum

cleaner or rinsing it under water.

4. Reposition the lter in the same way

as in gure 2 by sliding it to the right

or left.

5. Press the

button for 3 seconds.

This operation deletes the alarm. The

lter alarm is triggered again at the

end of 200 hours use.

1. Filter cleaning alarm: FILTER indicator

light solid red.

2. Remove the lter by sliding it to the

right or left of your appliance.

Page is loading ...

RADSON MUNA E T - MOUNTING Owner's manual

Brand: RADSON

Model: MUNA E T - MOUNTING

Category: Alarm clocks

Type: Owner's manual

This manual is also suitable for

MUNA E T

Download PDF

report

in other languages

français: RADSON MUNA E T - MOUNTING Le manuel du propriétaire
Nederlands: RADSON MUNA E T - MOUNTING de handleiding

RADSON MUNA E T - MOUNTING Owner's manual

This manual is also suitable for

RADSON MUNA E T - MOUNTING Owner's manual

in other languages

Related papers

Other documents