Zebra ST6085 Owner's manual

Type
Owner's manual
Page 1 of 2 Part No. 1005979 Revision A
Installation Instruction for ST6085 Rubber Boot
1. Installation of the ST6085 Grey Rubber Boot for Expansion Back WWAN End Cap
STEP 1.
INSERT HANDHELD THROUGH
OPENING IN THE RUBBER BOOT
AS SHOWN IN FIGURE A.
Continued on other side…
Figure A
STEP 2.
SECURELY FIT THE FRONT
END OF THE HANDHELD IN
THE END OF RUBBER BOOT.
SEE FIGURE B.
Figure B
Page 2 of 2 Part No. 1005979 Revision A
STEP 3.
FIRMLY PULL BOTTOM CORNERS OF RUBBER BOOT (ONE AT A TIME
WORKS BEST) AROUND THE END OF THE HANDHELD UNTIL SECURELY
ENCLOSED. AS SHOWN IN FIGURES C AND D.
Figure C Figure D
Appendix A: Support Services
Fortechnicalsupport,pleasevisittheSupportsectionofourcommunityIngenuityWorking:http://community.psion.com/support.
Figure E
STEP 4.
FIGURE E SHOWS THE
COMPLETED ASSEMBLY
OF THE RUBBER BOOT.
  • Page 1 1
  • Page 2 2

Zebra ST6085 Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI