Heath Zenith 6153/62/71/72 User manual

Type
User manual

This manual is also suitable for

© 2008 HeathCo LLC 595-5611-07
This package includes (Style of push button and chime may vary from illustration):
• Wirelesschime
• Wirelesspushbutton(model6162includes2)withbattery
• Hardwarepack
This chime requires 3 “D” alkaline batteries (not included). In typical use,
alkalinebatterieswilllastuptothreeyears.
Wireless Chime
Figure 1
WARNING: To prevent possible
SERIOUS INJURY or DEATH:
• NEVER allow small children near
batteries.
• If battery is swallowed, immediately
notifydoctor.
1. InstallalkalinetypeA2312voltpushbutton
battery(included). Remove back of case by
pushingintabonbottomwithasmallscrew-
driver(seeFigure1).Seediagraminsidepush
buttonforcorrectbatteryorientation.Note: If
batteries are preinstalled, remove orange
batterytab.
2. Openchimecase. Press in catch on bottom of
chimeandliftthecaseopen(seeFigure2).
3. Install 3 alkaline “D” batteries. Make sure
batteriesareorientedproperly(seeFigure3).
4. Test range. Temporarily position chime and
pushbuttonwhereyouwantthemmounted.
Press push button to verify chime and push
buttonworkproperly.Ifchimedoesnotsound,
see Troubleshooting.
5. Adjust volume control. Adjust volume control
todesiredvolume(seeFigure3).
Typ eD
Typ eD
Typ eD
Chime
Volume
Figure 2
Figure 3
Models6153/62/71/72
-2-
595-5611-07
6. Mount push button. Use either screws or double
sidedtapetomountpushbutton.
• ScrewMounting:To mountwithscrews,remove
backofcasebypushingintabonbottomwithasmall
screwdriver(seeFigure1).Note: Remove material in
screwholes(ifneeded)beforemountingwithscrews.
Attachbackofcasetodoorjamborwall(seeFigure
4).Snapfrontofpushbuttonon.
• Tape Mounting:Whenattachingpushbuttonusing
double sided tape, make sure the surface of the door
jamborwallisclean.
7. Mount chime. Chime can be mounted by using 3
holesinthebackofcase,orbyusing2screwswith
keyholes.
KeyholeMounting:Determinemountinglocation.
• Marktwoholelocations.Note:Makesureholesarelevelbeforedrilling.
• Models6153and6162
(see Figure 5)
:3-5/16"(8.4cm)apart.
• Models6171and6172
(see Figure 5)
:2-3/8"(6cm)apart.
• Drilltwo7/32"diameterpilotholesforwallanchorsandinsertanchors.
• Mountkeyholescrewstowallleavingabout1/8"(3mm)ofthescrewthreads
exposed.
•
Snapcoverontochimebase.
• Models6153and6162:Aligntopedgeofcasewithtopofbackplate.Rotate
bottomofcasetowardbackplateandsnapintoposition(seeFigure7).
• Models6171and6172:
Alignbottomedgeofcasewithbottomofback
plate.Rotatetopofcasetowardbackplateandsnapintoposition
(see
Figure7).
•
Usingkeyholesonbackofchimebase,hangbaseonscrews(seeFigure5).
ScrewMounting:Determinemountinglocation.
• Placechimeagainstwallandverifythechimeislevel.
• Usechimeholesasatemplate(seeFigure6).Drillthree7/32"diameterpilot
holesforwallanchors(provided)andinsertanchors.
• Insert3screws(provided)throughholesinbackofchime.
• Verifychimeislevelandtightenscrewssecurely.
•
Snapcoverontochimebase.
• Models6153and6162:Aligntopedgeofcasewithtopofbackplate.Rotate
bottomofcasetowardbackplateandsnapintoposition(seeFigure7).
• Models6171and6172:
Alignbottomedgeofcasewithbottomofback
plate.Rotatetopofcasetowardbackplateandsnapintoposition
(see
Figure7).
Figure 4
-3-
595-5611-07
3-5/16"
(8.4cm)
Holes
forWall
Mounting
Figure 5 - Keyhole
Mounting
Figure 6 - Screw
Mounting
Styleofchimemayvaryfromillustration.
2-3/8"
(6 cm)
Models6171and6172
Models6153and6162
Figure 7 - Attach
Cover
Models6171and6172
Models6153and6162
-4-
595-5611-07
Battery
Battery
Battery
Tune Settings
Yourwirelesschimehasdifferentselectabletunes:Ding (one note), Ding-Dong
(twonote),orWestminster(eightnote)(Availableonselectedchimes).The
factorysettingisfortheDing-Dongtune(orWestminster,whenavailable).This
tunecanbechangedbyfollowingtheinstructionsbelow.
• Ding (one note tune)
 InsidePushButton:Addajumpertolocation8.
• Ding-Dong(twonotetune)
 InsidePushButton:Removejumperfromlocation8.
 InsideChime:Removejumperfromlocation8.
• Westminster (Eight note tune) (Available on selected chimes)
 InsidePushButton:Removejumperfromlocation8.
 InsideChime:Addajumpertolocation8.
Note:Allmodelshavebothfrontandbackdoortunecapabilities.Werecommend
the back door use the Ding tune and the front door use the Ding-Dong tune
(or Westminstertune,availableonselectedchimes).Modelsthatincludetwo
pushbuttonswillcomefactorysetforfrontandbackdoors.Decalsontherear
ofthepushbuttonwillindicateitssetting.
Note: Some models might require the use of
tweezerstoremoveandreplacethejumpers.
Figure 8
1 2 3 4 5 6 7 8
Inside Push
Button
Tune Setting
Inside Chime
Tune Setting
(Not used on all
models)
1 2 3 4 5 6 7 8
-5-
595-5611-07
Troubleshooting
A. Chime does not sound:
• Makesurepushbuttonandchimecodesarethesame(seeFigure9).
• Checkorientationofpushbuttonandchimebatteries.(Seediagraminside
pushbuttonandchimeforcorrectbatteryorientation.)
• Checkchargeofpushbuttonandchimebatteries,replaceifnecessary.
B.Chimesoundswhennotintended(falsetriggers):Chime is receiving
interferencefrom anotherwirelessdevice;change the codesetting(see
Code Settingbelow).
C.BatteriesseemOK,butthechimedoesnotworkwheninstalled:
• Donotmountchimeorpushbuttononmetalornearmetalstuds.This
reducesthetransmitterrange.Use1/4"to1/2"(6to13mm)woodshims
tomovechimeorpushbuttonoffmetalsurface.
• Concreteoorsmayreducerange.Movechimeawayfromoor.
• Trylocatingchimeclosertopushbutton.
D. Code Setting:
It is recommended to only change one code position at a time and then check
toseeifsystemisfunctioningproperly.
1. Openthecasesandlocatethejumpersonboththepushbuttonandchime
(seeFigure9).
2. Thepushbuttonandchimebothhaveeightdifferentjumperlocations.Jumper
positions1through7areusedforsettingthecode.
-6-
595-5611-07
Battery
Battery
Battery
12345678
3. Tochangethecode,either(Formodelswith2pushbuttons,changecode
settinginbothpushbuttonstomatchchime.):
• Addajumpertothesamelocationonboththepushbuttonandthechime
or...
• Removeajumperfromthesamelocationonboththepushbuttonandthe
chime or...
• Moveajumperonthepushbuttonfromonelocationtoanother.Movethe
correspondingjumperonthechimetomatchthenewlocationinthepush
button.
Example: Move jumper at location “5” to location “4” on both the push
buttonandthechime.
Note:Codepositions1through7mustbeexactlythesameforboththe
pushbuttonandchimeforthissystemtofunction.
Note:Unitwillcomefactorysetwithjumpersinlocations5,6,and7onthe
pushbuttonandonthechime(seeFigure9).
The range of the wireless chime can vary with location, temperature, and
batterycondition.
* Code Settings 1-7
Must Match Both Push
Button and Chime
Inside Push
Button
Inside Chime
Note: Some models might require the use of
tweezerstoremoveandreplacethejumpers.
Figure 9
12345678
-7-
595-5611-07
Technical Service
Pleasecall1-800-858-8501(Englishspeakingonly)forassistance
beforereturningproducttostore.
Ifyouexperienceaproblem,followthisguide.Youmayalsowanttovisitour
Websiteat:www.hzsupport.com. If the problem persists, call* for assistance
at 1-800-858-8501,7:30AMto4:30PMCST(M-F).Youmayalsowrite*to:
HeathCo LLC
P.O.Box90045
BowlingGreen,KY42102-9045
ATTN: Technical Service
*IfcontactingTechnicalService,pleasehavethefollowinginformationavailable:
ModelNumber,DateofPurchase,andPlaceofPurchase.
NoServicePartsAvailableforthisProduct
Please keep your dated sales receipt,it is required for all warranty
requests.
RegulatoryInformation
ThisdevicecomplieswithPart15oftheFCCRulesandRSS-210ofIndustry
Canada.Operationissubjecttothefollowingtwoconditions:(1)thisdevicemay
not cause harmful interference, and (2) this device must accept any interference
received,includinginterferencethatmaycauseundesiredoperation.
The user is cautioned that changes or modifications not expressly approved by
the party responsible for regulatory compliance could void the user’s authority
tooperatetheequipment.
-8-
595-5611-07
HeathCo LLC reserves the right to discontinue and to change specifications
atanytimewithoutnoticewithoutincurringanyobligationtoincorporatenew
featuresinpreviouslysoldproducts.
FIVEYEARLIMITEDWARRANTY
Thisis a“LimitedWarranty”which givesyouspeciclegalrights.You
mayalsohaveotherrightswhichvary fromstatetostateorprovince
toprovince.
For a period of five years from the date of purchase, any malfunction
causedbyfactorydefectivepartsorworkmanshipwillbecorrectedat
nochargetoyou.
Not Covered - Repair service, adjustment and calibration due to misuse,
abuse or negligence, light bulbs, batteries, and other expendable items
arenotcoveredbythiswarranty.Unauthorizedserviceormodicationof
theproductorofanyfurnishedcomponentwillvoidthiswarrantyinits
entirety.Thiswarrantydoesnotincludereimbursementforinconvenience,
installation,setuptime,lossofuse,unauthorizedservice,orreturnship-
pingcharges.
ThiswarrantycoversonlyHeathCoLLCassembledproductsandisnot
extended to other equipment and components that a customer uses in
conjunctionwithourproducts.
THISWARRANTYISEXPRESSLYINLIEUOFALLOTHERWARRAN-
TIES,EXPRESSORIMPLIED,INCLUDINGANYWARRANTY,REPRE-
SENTATIONORCONDITIONOFMERCHANTABILITYORTHATTHE
PRODUCTSAREFITFORANYPARTICULARPURPOSEORUSE,AND
SPECIFICALLYINLIEUOFALLSPECIAL,INDIRECT,INCIDENTAL,OR
CONSEQUENTIALDAMAGES.
REPAIRORREPLACEMENTSHALLBETHESOLEREMEDYOFTHE
CUSTOMERANDTHERE SHALL BENOLIABILITY ONTHEPART
OFHEATHCOLLCFORANYSPECIAL,INDIRECT,INCIDENTAL,OR
CONSEQUENTIALDAMAGES,INCLUDINGBUTNOTLIMITEDTOANY
LOSSOFBUSINESSORPROFITS,WHETHERORNOTFORESEE-
ABLE.Somestatesorprovincesdonotallowtheexclusionorlimitationof
incidental or consequential damages, so the above limitation or exclusion
maynotapplytoyou.
Pleasekeepyourdatedsalesreceipt,itisrequiredforallwarranty
requests.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24

Heath Zenith 6153/62/71/72 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI