Heath Zenith Wireless Chime 598-1172-04 User manual

TYPE “D”

TR-0035-RX

This package includes (Style of push button and chime may vary from illustration):

• Wirelesschimecover • Wirelesschimebase

• Wirelesspushbuttonwithbattery • Hardwarepack

This chime requires 3 “D” alkaline batteries (not included). In typical use, alkaline batteries

willlastuptothreeyears.

Wireless Chime

Battery Cover

1. Install alkaline type A23 12 volt push button battery

(included). Remove back of case by pushing in tab on bot-

tomwithasmallscrewdriver(seeFigure1).Seediagram

insidepushbuttonforcorrectbatteryorientation.Note: If

batteriesarepreinstalled,removeorangebatterytab.

2. Remove chime cover. See page 2 to determine cover

mountingtype.

3. Install 3 alkaline “D” batteries.Pressdownonimprinted

arrowsandslidebatterycovertoremove(seeFigure3).

Makesurebatteriesareorientedproperly(seeFigure4).

4. Test range. Temporarily position chime and push button

whereyouwantthemmounted.Presspushbuttontoverify

chimeandpushbuttonworkproperly.Ifchimedoesnot

sound, see Troubleshooting.

Mounting

Holes

TYPE “D”

1 2 3 4 5 6 7 8

V O LUME

WARNING: To prevent possible SERIOUS INJURY

or DEATH:

 

 

Figure 1

Figure 2

Figure 3 Figure 4

Chime Volume

-2-

598-1172-04

TR-0035-RX

TR-0095-RX

TYPE

C

5. Adjust volume control. Adjust volume control to desired volume

(seeFigure3).

6. Mount push button. Useeitherscrews or doublesided tape to

mountpushbutton.

• Tomountwithscrews,removebackofcase

bypushingintabonbottomwithasmallscrewdriver(seeFigure

1).Attachbackofcasetodoorjamborwall(seeFigure5).Snap

frontofpushbuttonon.

• Tape Mounting:Whenattachingpushbuttonusingdoublesided

tape,makesurethesurfaceofthedoorjamborwallisclean.

7. Determine cover mounting type.Thecoversuppliedwiththechimebasewilleithersnap

ontothebaseorhangfromacoverpin.

• Snap-On Cover:Applypressuretothecoveruntilitsnapsintoplace(seeFigure6).To

remove,rmlygraspcoverandpull.

• Hanging Cover:Beforemountingchimebasetowall,slidethecoverpinthatwillbeon

topofthemountedbaseoutofthebase.Turnitoversothepinisprotrudingabovethe

base.Slidethecoverpinintobase(seeFigure7).Hangcoveroncoverpin.

Note:Coverpinsarelocatedontwosidesofthechimebaseforusewithhangingcovers.When

chime base is mounted according to mounting orientation marking, use the cover pin located

onthetopofthechimebaseforhangingthecover.

Cover Pin

Chime Base

Figure 6

Snap-On Cover

Mounted

Chime Base

Figure 7

Figure 5

-3-

598-1172-04

TYPE ‘D’

LR20

TYPE ‘D’

LR20

TR-0035-RX

Screw

Mounting

Orientation

Marking

Cover Pin Locations

Mounting Hole

WallAnchor

(If Needed)

Mounting Hole

8. Mount chime. Determine mounting loca-

tion.

• Placechimeagainstwallandverifythe

chimeislevel.Note: See chime base for

correctorientation.

• Useall 4chimemountingholesasa

template(seeFigure8).Note: 2 mount-

ing holes are located inside battery

compartment.Removebatteriesbefore

mounting.

• Drill7/32"diameterpilotholesforwall

anchors(provided)andinsertanchors.

Note: Alwaysusewallanchors if not

mountingdirectlyintoastud.

Figure 8

• Verifychimeislevelandtightenscrews

securely.

• Install batteries removed previously.

Make sure batteries are oriented prop-

erly(seeFigure4).

• Place chime cover onto chime base

(Seestep6todeterminecovermount-

ingtype).

-4-

598-1172-04

TYPE “D”

1 2 3 4 5 6 7 8

VOLUME

12345678

Note: Some models might require the use of

tweezerstoremoveandreplacethejumpers.

Inside Push Button

FrontofChimeBase

Tune Setting (Not

used on all models)

Tune Setting

Chime Volume

Control

TUNE SETTINGS

Yourwirelesschimehasdifferentselectabletunes:Ding (one note), Ding-Dong(twonote),orWest-

minster(eightnote)(Availableonselectedchimes).ThefactorysettingisfortheDing-Dongtune

(orWestminster,whenavailable).Thistunecanbechangedbyfollowingtheinstructionsbelow.

• Ding (one note tune)

 InsidePushButton:Addajumpertolocation8.

• Ding-Dong(twonotetune)

 InsidePushButton:Removejumperfromlocation8.

 FrontofChimeBase:Removejumperfromlocation8.

• Westminster (Eight note tune) (Available on selected chimes)

 InsidePushButton:Removejumperfromlocation8.

 FrontofChimeBase:Addajumpertolocation8.

Note:Allmodelshavebothfrontandbackdoortunecapabilities.Werecommendthebackdoor

use the Ding tune and the front door use the Ding-Dong tune (or Westminster tune, available

onselectedchimes).Modelsthatincludetwopushbuttonswillcomefactorysetforfrontand

backdoors.Decalsontherearofthepushbuttonwillindicateitssetting.

Figure 9

-5-

598-1172-04

TROUBLESHOOTING

A. Chime does not sound:

• Makesurepushbuttonandchimecodesarethesame(seeFigure10).

• Checkorientationofpushbuttonandchimebatteries.(Seediagraminsidepushbutton

andchimeforcorrectbatteryorientation.)

• Checkchargeofpushbuttonandchimebatteries,replaceifnecessary.

 Chime is receiving interference from

anotherwirelessdevice;changethecodesetting(seeCode Settingbelow).

 

• Donotmountchimeorpushbuttononmetalornearmetalstuds.Thisreducesthe

transmitterrange.Use1/4"to1/2"(6to13mm)woodshimstomovechimeorpush

buttonoffmetalsurface.

• Concreteoorsmayreducerange.Movechimeawayfromoor.

• Trylocatingchimeclosertopushbutton.

D. Code Setting:

It is recommended to only change one code position at a time and then check to see if system

isfunctioningproperly.

1. Openthecasesandlocatethejumpersonboththepushbuttonandchime(seeFigure

10).

2. Thepushbuttonandchimebothhaveeightdifferentjumperlocations.Jumperpositions1

through7areusedforsettingthecode.

Continued

-6-

598-1172-04

Note: Some models might require the use of

tweezerstoremoveandreplacethejumpers.

3. Tochangethecode,either:

• Addajumpertothesamelocationonboththepushbuttonandthechimeor...

• Removeajumperfromthesamelocationonboththepushbuttonandthechimeor...

• Moveajumperonthepushbuttonfromonelocationtoanother.Movethecorresponding

jumperonthechimetomatchthenewlocationinthepushbutton.

Example: Move jumper at location “5” to location “4” on both the push button and the

chime.

Note:



Note:Unitwillcomefactorysetwithjumpersinlocations5,6,and7onthepushbuttonand

onthechime(seeFigure10).

Therangeofthewirelesschimecanvarywithlocation,temperature,andbatterycondition.

Figure 10

TYPE “D”

1 2 3 4 5 6 7 8

VOLUME

12345678

Inside Push Button

FrontofChimeBase

* Code Settings 1-7

Must Match Both Push

Button and Chime

-7-

598-1172-04





product to store.

Ifyouexperienceaproblem,followthisguide.YoumayalsowanttovisitourWebsiteat:

hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501 (English speak-

ing only)7:30AMto4:30PMCST(M-F).Youmayalsowrite*to:

HeathCo LLC

P.O.Box90045

BowlingGreen,KY42102-9045

ATTN: Technical Service

*IfcontactingTechnicalService,pleasehavethefollowinginformationavailable:ModelNumber,

DateofPurchase,andPlaceofPurchase.





REGULATORY INFORMATION

ThisdevicecomplieswithPart15oftheFCCRulesandRSS-210ofIndustryCanada.Operation

issubjecttothefollowingtwoconditions:(1)thisdevicemaynotcauseharmfulinterference,

and (2) this device must accept any interference received, including interference that may

causeundesiredoperation.

The user is cautioned that changes or modiﬁcations not expressly approved by the party respon-

sibleforregulatorycompliancecouldvoidtheuser’sauthoritytooperatetheequipment.

-8-

598-1172-04

LIMITED WARRANTY

Thisisa“LimitedWarranty”whichgivesyouspeciclegalrights.Youmayalsohaveother

rightswhichvaryfromstatetostateorprovincetoprovince.

Foraspeciedperioddependinguponmodel(seechartbelow)fromthedateofpurchase,

anymalfunctioncausedbyfactorydefectivepartsorworkmanshipwillbecorrectedat

nochargetoyou.

Not Covered - Repair service, adjustment and calibration due to misuse, abuse or

negligence, light bulbs, batteries, and other expendable items are not covered by this

warranty.Unauthorizedserviceormodicationoftheproductorofanyfurnishedcompo-

nentwillvoidthiswarrantyinitsentirety.Thiswarrantydoesnotincludereimbursement

forinconvenience,installation,setuptime,lossofuse,unauthorizedservice,orreturn

shippingcharges.

ThiswarrantycoversonlyHeathCoLLCassembledproductsandisnotextendedtoother

equipmentandcomponentsthatacustomerusesinconjunctionwithourproducts.

THISWARRANTYISEXPRESSLYINLIEUOFALLOTHERWARRANTIES,EXPRESS

ORIMPLIED,INCLUDINGANYWARRANTY,REPRESENTATIONORCONDITIONOF

MERCHANTABILITYORTHATTHEPRODUCTSAREFITFORANYPARTICULAR

PURPOSEORUSE,ANDSPECIFICALLYINLIEUOFALLSPECIAL,INDIRECT,INCI-

DENTAL,ORCONSEQUENTIALDAMAGES.

REPAIRORREPLACEMENTSHALLBETHESOLEREMEDYOFTHECUSTOMERAND

THERESHALLBENOLIABILITYONTHEPARTOFHEATHCO LLCFORANYSPECIAL,

INDIRECT,INCIDENTAL,OR CONSEQUENTIALDAMAGES,INCLUDINGBUTNOT

LIMITEDTOANYLOSSOFBUSINESSORPROFITS,WHETHERORNOTFORESEE-

ABLE.Somestatesorprovincesdonotallowtheexclusionorlimitationofincidentalor

consequentialdamages,sotheabovelimitationorexclusionmaynotapplytoyou.



HeathCo LLC reserves the right to discontinue and to change speciﬁcations at any time

withoutnoticewithoutincurringanyobligationtoincorporatenewfeaturesinpreviouslysold

products.

Model Warranty Period

6600Series 1 Year

6210and6211 3Years

6240 5 Years

Page is loading ...

Heath Zenith Wireless Chime 598-1172-04 User manual

This manual is also suitable for

Heath Zenith Wireless Chime 598-1172-04 User manual

in other languages

Related papers

Other documents