Heath Zenith Wireless Chime 6153/62/71/72 User manual

This package includes (Style of push button and chime may vary from illustration):

• Wirelesschime

• Wirelesspushbutton(model6162includes2)withbattery

• Hardwarepack

This chime requires 3 “D” alkaline batteries (not included). In typical use,

alkalinebatterieswilllastuptothreeyears.

Wireless Chime

Figure 1

WARNING: To prevent possible

SERIOUS INJURY or DEATH:

• NEVER allow small children near

batteries.

• If battery is swallowed, immediately

notifydoctor.

1. InstallalkalinetypeA2312voltpushbutton

battery(included). Remove back of case by

pushingintabonbottomwithasmallscrew-

driver(seeFigure1).Seediagraminsidepush

buttonforcorrectbatteryorientation.Note: If

batteries are preinstalled, remove orange

batterytab.

2. Openchimecase. Press in catch on bottom of

chimeandliftthecaseopen(seeFigure2).

3. Install 3 alkaline “D” batteries. Make sure

batteriesareorientedproperly(seeFigure3).

4. Test range. Temporarily position chime and

pushbuttonwhereyouwantthemmounted.

Press push button to verify chime and push

buttonworkproperly.Ifchimedoesnotsound,

see Troubleshooting.

5. Adjust volume control. Adjust volume control

todesiredvolume(seeFigure3).

Typ e “D”

Chime

Volume

Figure 2

Figure 3

Models6153/62/71/72

-2-

595-5611-07

6. Mount push button. Use either screws or double

sidedtapetomountpushbutton.

• ScrewMounting:To mountwithscrews,remove

backofcasebypushingintabonbottomwithasmall

screwdriver(seeFigure1).Note: Remove material in

screwholes(ifneeded)beforemountingwithscrews.

Attachbackofcasetodoorjamborwall(seeFigure

4).Snapfrontofpushbuttonon.

• Tape Mounting:Whenattachingpushbuttonusing

double sided tape, make sure the surface of the door

jamborwallisclean.

7. Mount chime. Chime can be mounted by using 3

holesinthebackofcase,orbyusing2screwswith

keyholes.

KeyholeMounting:Determinemountinglocation.

• Marktwoholelocations.Note:Makesureholesarelevelbeforedrilling.

• Models6153and6162

(see Figure 5)

:3-5/16"(8.4cm)apart.

• Models6171and6172

(see Figure 5)

:2-3/8"(6cm)apart.

• Drilltwo7/32"diameterpilotholesforwallanchorsandinsertanchors.

• Mountkeyholescrewstowallleavingabout1/8"(3mm)ofthescrewthreads

exposed.

•

Snapcoverontochimebase.

• Models6153and6162:Aligntopedgeofcasewithtopofbackplate.Rotate

bottomofcasetowardbackplateandsnapintoposition(seeFigure7).

• Models6171and6172:

Alignbottomedgeofcasewithbottomofback

plate.Rotatetopofcasetowardbackplateandsnapintoposition

(see

Figure7).

•

Usingkeyholesonbackofchimebase,hangbaseonscrews(seeFigure5).

ScrewMounting:Determinemountinglocation.

• Placechimeagainstwallandverifythechimeislevel.

• Usechimeholesasatemplate(seeFigure6).Drillthree7/32"diameterpilot

holesforwallanchors(provided)andinsertanchors.

• Insert3screws(provided)throughholesinbackofchime.

• Verifychimeislevelandtightenscrewssecurely.

•

Snapcoverontochimebase.

• Models6153and6162:Aligntopedgeofcasewithtopofbackplate.Rotate

bottomofcasetowardbackplateandsnapintoposition(seeFigure7).

• Models6171and6172:

Alignbottomedgeofcasewithbottomofback

plate.Rotatetopofcasetowardbackplateandsnapintoposition

(see

Figure7).

Figure 4

-3-

595-5611-07

3-5/16"

(8.4cm)

Holes

forWall

Mounting

Figure 5 - Keyhole

Mounting

Figure 6 - Screw

Mounting

Styleofchimemayvaryfromillustration.

2-3/8"

(6 cm)

Models6171and6172

Models6153and6162

Figure 7 - Attach

Cover

Models6171and6172

Models6153and6162

-4-

595-5611-07

Battery

Tune Settings

Yourwirelesschimehasdifferentselectabletunes:Ding (one note), Ding-Dong

(twonote),orWestminster(eightnote)(Availableonselectedchimes).The

factorysettingisfortheDing-Dongtune(orWestminster,whenavailable).This

tunecanbechangedbyfollowingtheinstructionsbelow.

• Ding (one note tune)

 InsidePushButton:Addajumpertolocation8.

• Ding-Dong(twonotetune)

 InsidePushButton:Removejumperfromlocation8.

 InsideChime:Removejumperfromlocation8.

• Westminster (Eight note tune) (Available on selected chimes)

 InsidePushButton:Removejumperfromlocation8.

 InsideChime:Addajumpertolocation8.

Note:Allmodelshavebothfrontandbackdoortunecapabilities.Werecommend

the back door use the Ding tune and the front door use the Ding-Dong tune

(or Westminstertune,availableonselectedchimes).Modelsthatincludetwo

pushbuttonswillcomefactorysetforfrontandbackdoors.Decalsontherear

ofthepushbuttonwillindicateitssetting.

Note: Some models might require the use of

tweezerstoremoveandreplacethejumpers.

Figure 8

1 2 3 4 5 6 7 8

Inside Push

Button

Tune Setting

Inside Chime

Tune Setting

(Not used on all

models)

1 2 3 4 5 6 7 8

-5-

595-5611-07

Troubleshooting

A. Chime does not sound:

• Makesurepushbuttonandchimecodesarethesame(seeFigure9).

• Checkorientationofpushbuttonandchimebatteries.(Seediagraminside

pushbuttonandchimeforcorrectbatteryorientation.)

• Checkchargeofpushbuttonandchimebatteries,replaceifnecessary.

B.Chimesoundswhennotintended(falsetriggers):Chime is receiving

interferencefrom anotherwirelessdevice;change the codesetting(see

Code Settingbelow).

C.BatteriesseemOK,butthechimedoesnotworkwheninstalled:

• Donotmountchimeorpushbuttononmetalornearmetalstuds.This

reducesthetransmitterrange.Use1/4"to1/2"(6to13mm)woodshims

tomovechimeorpushbuttonoffmetalsurface.

• Concreteoorsmayreducerange.Movechimeawayfromoor.

• Trylocatingchimeclosertopushbutton.

D. Code Setting:

It is recommended to only change one code position at a time and then check

toseeifsystemisfunctioningproperly.

1. Openthecasesandlocatethejumpersonboththepushbuttonandchime

(seeFigure9).

2. Thepushbuttonandchimebothhaveeightdifferentjumperlocations.Jumper

positions1through7areusedforsettingthecode.

-6-

595-5611-07

Battery

12345678

3. Tochangethecode,either(Formodelswith2pushbuttons,changecode

settinginbothpushbuttonstomatchchime.):

• Addajumpertothesamelocationonboththepushbuttonandthechime

or...

• Removeajumperfromthesamelocationonboththepushbuttonandthe

chime or...

• Moveajumperonthepushbuttonfromonelocationtoanother.Movethe

correspondingjumperonthechimetomatchthenewlocationinthepush

button.

Example: Move jumper at location “5” to location “4” on both the push

buttonandthechime.

Note:Codepositions1through7mustbeexactlythesameforboththe

pushbuttonandchimeforthissystemtofunction.

Note:Unitwillcomefactorysetwithjumpersinlocations5,6,and7onthe

pushbuttonandonthechime(seeFigure9).

The range of the wireless chime can vary with location, temperature, and

batterycondition.

* Code Settings 1-7

Must Match Both Push

Button and Chime

Inside Push

Button

Inside Chime

Note: Some models might require the use of

tweezerstoremoveandreplacethejumpers.

Figure 9

12345678

-7-

595-5611-07

Technical Service

Pleasecall1-800-858-8501(Englishspeakingonly)forassistance

beforereturningproducttostore.

Ifyouexperienceaproblem,followthisguide.Youmayalsowanttovisitour

Websiteat:www.hzsupport.com. If the problem persists, call* for assistance

at 1-800-858-8501,7:30AMto4:30PMCST(M-F).Youmayalsowrite*to:

HeathCo LLC

P.O.Box90045

BowlingGreen,KY42102-9045

ATTN: Technical Service

*IfcontactingTechnicalService,pleasehavethefollowinginformationavailable:

ModelNumber,DateofPurchase,andPlaceofPurchase.

NoServicePartsAvailableforthisProduct

Please keep your dated sales receipt,it is required for all warranty

requests.

RegulatoryInformation

ThisdevicecomplieswithPart15oftheFCCRulesandRSS-210ofIndustry

Canada.Operationissubjecttothefollowingtwoconditions:(1)thisdevicemay

not cause harmful interference, and (2) this device must accept any interference

received,includinginterferencethatmaycauseundesiredoperation.

The user is cautioned that changes or modiﬁcations not expressly approved by

the party responsible for regulatory compliance could void the user’s authority

tooperatetheequipment.

-8-

595-5611-07

HeathCo LLC reserves the right to discontinue and to change speciﬁcations

atanytimewithoutnoticewithoutincurringanyobligationtoincorporatenew

featuresinpreviouslysoldproducts.

FIVEYEARLIMITEDWARRANTY

Thisis a“LimitedWarranty”which givesyouspeciclegalrights.You

mayalsohaveotherrightswhichvary fromstatetostateorprovince

toprovince.

For a period of ﬁve years from the date of purchase, any malfunction

causedbyfactorydefectivepartsorworkmanshipwillbecorrectedat

nochargetoyou.

Not Covered - Repair service, adjustment and calibration due to misuse,

abuse or negligence, light bulbs, batteries, and other expendable items

arenotcoveredbythiswarranty.Unauthorizedserviceormodicationof

theproductorofanyfurnishedcomponentwillvoidthiswarrantyinits

entirety.Thiswarrantydoesnotincludereimbursementforinconvenience,

installation,setuptime,lossofuse,unauthorizedservice,orreturnship-

pingcharges.

ThiswarrantycoversonlyHeathCoLLCassembledproductsandisnot

extended to other equipment and components that a customer uses in

conjunctionwithourproducts.

THISWARRANTYISEXPRESSLYINLIEUOFALLOTHERWARRAN-

TIES,EXPRESSORIMPLIED,INCLUDINGANYWARRANTY,REPRE-

SENTATIONORCONDITIONOFMERCHANTABILITYORTHATTHE

PRODUCTSAREFITFORANYPARTICULARPURPOSEORUSE,AND

SPECIFICALLYINLIEUOFALLSPECIAL,INDIRECT,INCIDENTAL,OR

CONSEQUENTIALDAMAGES.

REPAIRORREPLACEMENTSHALLBETHESOLEREMEDYOFTHE

CUSTOMERANDTHERE SHALL BENOLIABILITY ONTHEPART

OFHEATHCOLLCFORANYSPECIAL,INDIRECT,INCIDENTAL,OR

CONSEQUENTIALDAMAGES,INCLUDINGBUTNOTLIMITEDTOANY

LOSSOFBUSINESSORPROFITS,WHETHERORNOTFORESEE-

ABLE.Somestatesorprovincesdonotallowtheexclusionorlimitationof

incidental or consequential damages, so the above limitation or exclusion

maynotapplytoyou.

Pleasekeepyourdatedsalesreceipt,itisrequiredforallwarranty

requests.

Page is loading ...

Heath Zenith Wireless Chime 6153/62/71/72, 6153/62/71/72, 6171, 6172 User manual

Related papers

Other documents