Sealife SportDiver Smartphone Housing Pre-Dive Checklist Operating instructions

Hello! I've reviewed the SeaLife SportDiver user manual and am here to help you get the most out of your smartphone housing. This document provides step-by-step checklists for both pre-dive preparation and post-dive care, covering everything from testing your gear to storing your housing properly. Ask me any questions and I'll be happy to assist!
What should I do before my trip?

What settings should I apply to my phone before diving?

How do I take care of housing after a dive?

1. TEST all your gear before your trip.

2. PACK SPARES of essenal items like o-rings, lube, Moisture Muncher, and baeries.

3. PREPARE yourself by reviewing the manual and maintenance instrucons.

4. CHARGE your phone baery.

5. CHECK housing baeries and Moisture Muncher are in place; DO NOT TOUCH moisture

sensor.

6. CLEAN & LUBE housing and check port o-ring, use a thin coang of lube.

7. SET the PHONE to Airplane mode: ON; Bluetooth: ON; Do not Disturb: ON.

8. CLEAN phone display screen, and lenses and lens port of the SportDiver Housing, re-

move any phone cover or case.

9. POWER ON the housing and open the SportDiver app.

10. PLACE the PHONE in the HOUSING & SEAL it, allow it to adjust to outside temperature,

then apply specied pressure using vacuum pump.

11. CHECK online Troubleshoong if you experience any problems.

12. SOAK & RINSE the SportDiver housing in fresh water pushing all buons to ush out

any salt water.

13. DRY the SportDiver housing using a towel, making certain the housing and you are

completely dry.

14. RELEASE vacuum pressure, while making sure no water is present under the check port

cap.

15. OPEN the housing with the lens facing up to avoid any drops from geng inside the

housing

16. POWER OFF the housing,

17. STORE the housing in a cool, dry place with the door slightly open (unlatched)

>> View the Pre-Dive Checklist Video <<

Aer your Dive:

Before your Dive: