INSTALLATION INSTRUCTIONS FOR STAINLESS STEEL OUTDOOR
WEATHER COVERS 36-EODC (P/N H4647) AND 42-EODC (P/N H4648)
OUTDOOR WEATHER COVER
HEARTH PRODUCTS
KITS AND ACCESSORIES
P/N 750211M
Rev. A 04/2014
Printed in U.S.A. © 2006 IHP
P/N 750211M REV. A 04/2014
IHP reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor
for fireplace code information.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
GENERAL INFORMATION
The Stainless Steel Outdoor Weather Cover, is an available accessory to
provide protection for the interior of your Outdoor Gas Fireplace, Models
Polaris™ 36/42, VRE43 36/42, E36ODG and E42ODG. The cover is not
designed to fit over the optional doors.
Read this instruction sheet in its entirety before beginning.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
SHUT DOWN THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
INSTALLATION INSTRUCTIONS
To install the weather cover, refer to Figure 1 and follow the steps
outlined below:
Step 1. Insert the upper flange of the cover into the face top opening.
Step 2. Push the bottom towards the fireplace, while holding the
cover up at the same time.
Step 3. Hook the bottom of the weather cover inside the face opening
as shown in Figure 1.
Figure 1
Insert Upper Flange
Into The Face Top
Opening
Push The Bottom
Towards The Fireplace,
While Holding The Cover
Up At The Same Time. Support Frame
Insert Upper Flange
Into The Face Top
Opening
Push The Bottom
Towards The Fireplace,
While Holding The Cover
Up At The Same Time. Support Frame
Innovative Hearth Products (IHP)
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210