The Synchronizer – Control Module

SAFETY AND INSTALLATION INSTRUCTIONS

According to the requirements of the National Electric Code (NEC), direct

burial rated wire is to be buried a minimum of 6” [152mm] beneath the surface

of the ground.

NOTE: If additional Direct Burial wire is needed, contact your local Kichler®

landscape distributor.

• 8GAwirecanbepurchasedinlengthof250’(76M),15503-BK.

• 10GAwirecanbepurchasedinlengthof250’(76M),15504-BK.

• 12GAwirecanbepurchasedinlengthsof100’(30M),15501-BK;250’(76M),

 15502-BK;500’(152M),15505-BK;and1000’(304M),15506-BK.

The Synchronizer is a control module created to omit on/off timing disparities,

2) Installaswitchingdevice,suchasatimer,photocellorX-10devicein

transformer #1. The switching device will control all of the transformers in

the system that are connected using a Synchronizer.

3) PluginoneSynchronizerintoeachadditionaltransformer(#2,#3,#4,etc.)

intended to be controlled.

4) Alow-voltagewire,nosmallerthan#24-2gauge,shouldberunfromany

volt source from transformer #1 to the Synchronizer in transformer #2. A

  wireshouldberunfromtransformer#2totransformer#3,awireshould

  berunfromtransformer#3totransformer#4,etc.untilalltransformersare

connected.

1) Awirenosmallerthan#24-2gaugeshouldberunfromanylowvoltage

power source (Junction, fixture or transformer) located after the switching

device on transformer #1 to the Synchronizer on the distant transformer.

(See Fig. 2 for junction wiring suggestions.)

2) To synchronize all transformers, repeat this process.

DateIssued:9/21/07 IS-15511-CB

Transformer #1

w/Timer

Transformer #2

w/Synchronizer

Transformer #3

w/Synchronizer

Transformer #1

w/Timer

FIG. 2

Transformer #1

w/Timer

Transformer #2

#24 GA (MIN)

#8, #10 OR #12 GA

Transformer #2

w/Synchronizer

#24 GA (MIN)

NORMAL OPERATING CONDITIONS, PROVIDED IT IS RETURNED TO THE POINT OF PURCHASE, WHERE IT WILL BE REPAIRED OR, AS IT

MAY BE DETERMINED, TO REPLACE THE LANDSCAPE PRODUCT OR PARTS USED ON THAT PRODUCT.