Karran Karran Laguna - Bisque Installation guide

FOR THE INSTALLER

INSTALLATION GUIDELINES

To cut out countertop, invert sink and position onto

the countertop. Locate sink front to rear and so that

the bowls will not interfere with the cabinets below.

Trace a line around the outside edge of the sink and

remove sink from countertop.

Measure 1/2” in from the initial sink outline and draw

a second line inside of the first. Draw a radius at

each corner that matches the outer radius of the

sink. This second inside line will be your cut line.

Drill a starter hole inside of the cutout line.

Using a jigsaw, cut just inside the cutout line. Once

the hole is cut, do a trail fit of the sink to check that it

fits properly.

After the trail fit remove the sink and apply a bead of

silicone (not included) to the underside of the sink

flange and position the sink in the countertop

opening.

Attach clips as illustrated. Sink clips will accommo-

date countertops up to 1” thick. If your countertop is

over 1” thick, please call Karran at 866-452-7726 to

order extended clips.

APPLY SILICONE

This manual is also suitable for

Download PDF