MFJ 82 Screwdriver Antenna Remote Sensor Add-on Kit is a simple kit that can be installed on your screwdriver antenna to allow you to enjoy the convenience of quickly and accurately returning to antenna settings, when used with the MFJ-1924 Screwdriver Antenna Digital Controller With Counter.
The kit includes a magnet and bracket assembly, a surface mount magnetic contact (switch), two heavy duty cable straps, a stainless steel split washer, a ¼-20 stainless steel nut, a 5-ohm ceramic resistor, and two lengths of switch wire (one brown, one white).
To install the kit, you will need to disassemble your screwdriver antenna, install the magnet bracket and magnetic switch, and reassemble the antenna. Once the kit is installed, you will need to connect the sensor wires from the antenna to the digital controller.
MFJ 82 Screwdriver Antenna Remote Sensor Add-on Kit is a simple kit that can be installed on your screwdriver antenna to allow you to enjoy the convenience of quickly and accurately returning to antenna settings, when used with the MFJ-1924 Screwdriver Antenna Digital Controller With Counter.
The kit includes a magnet and bracket assembly, a surface mount magnetic contact (switch), two heavy duty cable straps, a stainless steel split washer, a ¼-20 stainless steel nut, a 5-ohm ceramic resistor, and two lengths of switch wire (one brown, one white).
To install the kit, you will need to disassemble your screwdriver antenna, install the magnet bracket and magnetic switch, and reassemble the antenna. Once the kit is installed, you will need to connect the sensor wires from the antenna to the digital controller.
MFJ 82 Screwdriver Antenna Remote Sensor Add-on Kit is a simple kit that can be installed on your screwdriver antenna to allow you to enjoy the convenience of quickly and accurately returning to antenna settings, when used with the MFJ-1924 Screwdriver Antenna Digital Controller With Counter.
The kit includes a magnet and bracket assembly, a surface mount magnetic contact (switch), two heavy duty cable straps, a stainless steel split washer, a ¼-20 stainless steel nut, a 5-ohm ceramic resistor, and two lengths of switch wire (one brown, one white).
To install the kit, you will need to disassemble your screwdriver antenna, install the magnet bracket and magnetic switch, and reassemble the antenna. Once the kit is installed, you will need to connect the sensor wires from the antenna to the digital controller.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI