Atel FJ1510MA User manual

Page | 1

FJ1510M‐UserMannual

1 Plug in the test wire

Plugthe test wire of TM97 into the device as follows:

1 Start the device

To power the device, a 12V adapter is plugged directly into the DC female head of the test line.

The green light of the device will flash to represent the power on.

Page | 2

2 SIM card (4FF micro SIM size) installation

a. Open the top plastic，Then unscrew the three screws and take the machine out and

turn it around.

as shown below：

Page | 3

6

FCCStatement

Thisdevicecomplieswithpart15oftheFCCRules.Operationissubjecttothefollowingtwoconditions:(1)

Thisdevicemaynotcauseharmfulinterference,and(2)thisdevicemustacceptanyinterferencereceived,

includinginterferencethatmaycauseundesiredoperation.Thisequipmenthasbeentestedandfoundto

complywiththelimitsforaClassBdigitaldevice,pursuanttopart15oftheFCCRules.Theselimitsare

designedtoprovidereasonableprotectionagainstharmfulinterferenceinaresidentialinstallation.This

equipmentgenerates,usesandcanradiateradiofrequencyenergyand,ifnotinstalledandusedin

accordancewiththeinstructions,maycauseharmfulinterferencetoradiocommunications.However,there

isnoguaranteethatinterferencewillnotoccurinaparticularinstallation.Ifthisequipmentdoescause

harmfulinterferencetoradioortelevisionreception,whichcanbedeterminedbyturningtheequipmentoff

andon,theuserisencouragedtotrytocorrecttheinterferencebyoneormoreofthefollowingmeasures:

—Reorientorrelocatethereceivingantenna.

—Increasetheseparationbetweentheequipmentandreceiver.

—Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.

—Consultthedealeroranexperiencedradio/TVtechnicianforhelp.

　Changesormodificationsnotexpresslyapprovedbythemanufacturercouldvoidtheuser’sauthorityto

operatetheequipment.



FCC RF Radiation Exposure Statement

ThisequipmentcomplieswithFCCradiationexposurelimitssetforthforanuncontrolledenvironment.To

complywithFCCRFExposurecompliancerequirements,thisgrantisapplicabletoonlyMobile

Configurations.Theantennasusedforthetransmittermustbeinstalledtoprovideaseparationdistanceof

atleast20cmfromallpersonsandmustnotbeco‐locatedoroperatinginconjunctionwithanyother

antennaortransmitter.

ISED Warning statements

This device complies with Canada's licence-exempt RSSs. Operation is subject to the following

two conditions:

(l) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired

operation of the device.

Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio

exempts de licence.

L'exploitationestautorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de

brouillage, et (2) l'utilisateur de

l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest susceptible

d'encompromettre le fonctionnement.

This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled

environment. This equipment should be

installed and operated with a minimum distance of 20cm between the radiator and any part of

your body.

Pour se conformer aux exigences de conformité CNR 102 RF exposition, une distance de

séparationd'aumoins 20 cm doitêtremaintenue

entre l'antenne de cetappareilettoutes les personnes.

This Class B digital apparatus complies with Canadian ICES-003.

Cetappareilnumeriquede la classe B estconforme a la norme NMB-003 du Canada.

Atel FJ1510MA User manual

Other documents