Rod Desyne RS-80 Installation guide

Multi- Purpose Rod Stand

Common Uses:

• Cubicle Space Divider

• Studio Background Stand

• Banner Holder

• Projection Screen Frame

Part List:

2 Stands, (3 parts each)

2 Cross Bars, ( 2 parts each)

2 Stand Connectors

Bolts & Washers & Nuts

Assembly Instructions

(1) Unpack the carton, verify you have all of the parts

(2) Slide the stands together and bolt the junction with hex nuts, bolts, and washers

(3) Connect the stands to the feet and bolt them together using hex nuts, bolts, and washers

(4) Screw the 2 cross bars together, and fasten the stand connectors to their ends.

(5) Optional: Insert curtain /screen onto the cross-bar.

(6) Use the machine screws and bolts to fasten the completed crossbar- connector to the stand

at the 4 junction points , right and left, top and bottom

This Multi- Purpose Rod Stand is also suitable for the

construction of cubical partitions. The varied feet height on

the stands allows for a tight junction at the corners.

NOTE:CURTAIN / SCREEN NOT INCLUDED.

This manual is also suitable for