Patio Festival PF19120-220-G Operating instructions

Type
Operating instructions

This manual is also suitable for

ASSEMBLY INSTRUCTIONS
ASSEMBLY TIPS: Please use the hardware and
accessories included in the set. DO NOT use other
electrical or manual tools.
In order to facilitate the assembly and make your final
product firm and stable, please tighten by a few
rounds each screw one by one. After all screws are
connected, then you start to tighten each screw to
the end.
DO NOT tighten any screw to the end before you’ve
connected all screws.
The assembly requires minimal level of DIY skills if you
follow the instructions carefully. In case you
encounter any difficulty or have any questions, feel
free to contact the store or manufacturer.
A
B
C
D
E
F
G
H
1
1
1
1
10
10
10
1
Part# Reference Image QTY
Connect chair seat board (D) with chair backrest (A).
Please do not tighten bolts to the end at this step.
Connect armrests (A and B) with backrest and seat board.
Make sure all bolts are inserted and connected properly,
then tighten all bolts to the end.
C
D
E
GF
A
B
EGF
EGF
STEP 1
STEP 2
Finish and enjoy your chair.
M*18
ASSEMBLY TIPS: Please use the hardware and accessories included in the
set. DO NOT use other electrical or manual tools.
In order to facilitate the assembly and make your final product firm and
stable, please tighten by a few rounds each screw one by one. After all
screws are connected, then you start to tighten each screw to the end.
DO NOT tighten any screw to the end before you’ve connected all screws.
The assembly requires minimal level of DIY skills if you follow the
instructions carefully. In case you encounter any difficulty or have any
questions, feel free to contact the store or manufacturer.
ASSEMBLY INSTRUCTIONS
Part#
Reference Image
QTY
A
B
C
D
E
F
G
H
I
1
4
1
1
8
8
16
16
1
M6*28
M6*15
B
F
H
G
F
H
G
A
Place table board (A) on the ground, connect table legs (B) with it.
M6*15 bolts (F), spring washers (H) and washers (G) are used.
Please do not tighten screws to the end at this step.
E
H
G
E
H
G
C
Connect table leg support ring (C) with table legs.
M6*28 bolts, spring washers (H) and washers (G) are used.
Please do not tighten bolts to the end at first.
Make sure all bolts are inserted and connected properly,
then tighten all bolts to the end.
Put umbrella hole lid (D) on the table.
Finish and enjoy your table.
D
STEP 1
STEP 2
STEP 3
  • Page 1 1
  • Page 2 2
  • Page 3 3

Patio Festival PF19120-220-G Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI