GROHE 19592000 Installation guide

D

.....1

NL

.....6

PL

.....11

P

.....16

BG

.....21

CN

.....26

GB

.....2

S

.....7

UAE

.....12

TR

.....17

EST

.....22

UA

.....27

F

.....3

DK

.....8

GR

.....13

SK

.....18

LV

.....23

RUS

.....28

E

.....4

N

.....9

CZ

.....14

SLO

.....19

LT

.....24

I

.....5

FIN

...10

H

.....15

HR

.....20

RO

.....25

DESIGN + ENGINEERING

GROHE GERMANY

www.grohe.com

19 592

BAULOOP

99.568.131/ÄM 224926/08.12

English .....4

Français .....6

Español .....8

I

S.v.p remettre cette instruction à l'utilisateur de la robinetterie!

Entregue estas instrucciones al usario final de la grifería!

Please pass these instructions on to the end user of the fitting!

1

Page is loading ...

4

English

Application

Operation is possible in conjunction with:

- Pressurized storage heaters

Operation is not possible with:

- Low-pressure storage heaters

(displacement water heaters)

Technical data

• Max. flow

- Spout approx. 28 l/min or 7.2 gpm/45psi

- Handshower max. 9.5 l/min or 2.5 gpm/45psi

• Flow pressure

- min. 7.25 psi

- recommended 14.5 - 72.5 psi

- greater than 72.5 psi, fit with pressure reducing valves

• Max. operating pressure 145 psi

• Test pressure 232 psi

• Temperature

- max. (hot water inlet) 176 °F

- Scalding protection possible by fitting a handle rotation

stop (see replacement page 2, order no. 46 375).

• Water connection cold - Right hand

hot - Left hand

Notes

• Installation of backflow protection must comply with local

codes and regulations.

• An access panel must be provided for access to diverting

unit and hose connections.

• Major pressure differences between cold and hot water

supply should be avoided.

Installation

Layout dimensions to establish centers and proper clearences,

see dimensional drawing page 1.

Flush piping system prior and after installation of faucet

thoroughly!

Installing faucet body, see fig. [1].

1. Fit faucet body (A) with mounting set (B).

2. Fit adapter (C).

Spout, see fig. [2].

1. Place the O-ring (D1) on the tub deck and insert the

spout (D) from above.

2. Secure the spout with the mounting set (E).

3. Install the diverter (F) to the spout, gently guiding the lift rod

assembly (G) up through the center of the spout (D).

4. Tighten the lift rod knob (H) to lift rod assembly (G).

Handshower, see fig. [3] and [4].

1. Install the escutcheon (J) onto the guide (K), see fig. [3].

2. Install the guide (K) through the mounting surface, insure

the escutcheon washer (K1) is in place.

3. Secure with mounting set (L).

4. Insert shower hose (M) through guide (K) from below.

5. Screw tapered nut (N) onto shower hose (M).

6. Insert seal (N1) into the tapered nut (N) and screw hand

shower (O) into tapered nut (N).

7. Install shower hose (M) with hose (P), see fig. [4].

Connect the faucet, see fig. [4] and [5].

The hot water supply should be connected on the left, the cold

water supply on the right side.

Insure the supplied washers are used for all connections.

Open cold and hot water supply and check connections

for leakage!

Operation

- Lever

Pull lever = open (water flow)

Press lever down = closed

Turn lever right = cold water

Turn lever left = hot water

- Diverter

Pulling the lever will release water supply.

Water will emerge from the bath spout first.

Pull diverter knob = to divert flow from bath spout to

shower outlet

Press diverter knob = to divert flow from shower outlet to

bath spout

Flow is diverted automatically from shower outlet to bath spout

when the mixer is turned off.

Maintenance

Inspect and clean all parts, replace as necessary and grease

with special grease.

Shut off cold and hot water supply!

I. Replacing the cartridge, see fig. [6].

1.Lever out plug (Q).

2.Loosen set screw (Q1) with 3mm allen wrench and pull off

lever (R).

3.Unscrew cap (S).

4.Remove screws (T).

5.Replace complete cartridge (U).

Assemble in reverse order.

Observe the correct installation position.

Make sure that the cartridge seals engage in the grooves on

the housing. Fit screws (T) and tighten evenly and

alternately.

II. Check valve, see fig [4].

1. Disconnect hose (P).

2. Remove check valve (V).

Assemble in reverse order.

III. Unscrew and clean flow control (13 905), see page 2.

Replacement parts, see page 2 ( * = special accessories).

Care

Instructions for care of this faucet will be found in the Limited

Warranty supplement.

Page is loading ...

2014/03/21

www.grohe.com

D

&

+49 571 3989 333

impressum@grohe.de

A

&

+43 1 68060

info-at@grohe.com

AUS

Argent Sydney

&

+(02) 8394 5800

Argent Melbourne

&

+(03) 9682 1231

B

&

+32 16 230660

info.be@grohe.com

BG

&

+359 2 9719959

grohe-bulgaria@grohe.com

CAU

&

+99 412 497 09 74

[email protected]

CDN

&

+1 888 6447643

[email protected]

CH

&

+41 448777300

[email protected]

CN

&

+86 21 63758878

CY

&

+357 22 465200

[email protected]

CZ

&

+420 277 004 190

grohe-cz@grohe.com

DK

&

+45 44 656800

[email protected]

E

&

+34 93 3368850

[email protected]

EST

&

+372 6616354

[email protected]

F

&

+33 1 49972900

marketing-fr@grohe.com

FIN

&

+358 10 8201100

teknocalor@teknocalor.fi

GB

&

+44 871 200 3414

[email protected]

GR

&

+30 210 2712908

nsapountzis@ath.forthnet.gr

H

&

+36 1 2388045

[email protected]

HK

&

+852 2969 7067

[email protected]

I

&

+39 2 959401

[email protected]m

IND

&

+91 124 4933000

[email protected]

IS

&

+354 515 4000

[email protected]

J

&

+81 3 32989730

[email protected]o.jp

KZ

&

+7 727 311 07 39

[email protected]

LT

&

+372 6616354

[email protected]

LV

&

+372 6616354

grohe@grohe.ee

MAL

&

+1 800 80 6570

info-singapore@grohe.com

N

&

+47 22 072070

grohe@grohe.no

NL

&

+31 79 3680133

[email protected]

NZ

&

+09/373 4324

P

&

+351 234 529620

[email protected]

PL

&

+48 22 5432640

[email protected].pl

RI

&

+62 21 2358 4751

info-singapore@grohe.com

RO

&

+40 21 2125050

info-ro@grohe.com

ROK

&

+82 2 559 0790

info-singapore@grohe.com

RP

&

+63 2 8041617

RUS

&

+7 495 9819510

info@grohe.ru

S

&

+46 771 141314

[email protected]

SGP

&

+65 6 7385585

info-singapore@grohe.com

SK

&

+420 277 004 190

[email protected]

T

&

+66 2610 3685

info-singapore@grohe.com

TR

&

+90 216 441 23 70

GroheTurke[email protected]

UA

&

+38 44 5375273

info-ua@grohe.com

USA

&

+1 800 4447643

us-customerservice@grohe.com

VN

&

+84 8 5413 6840

info-singapore@grohe.com

BiH

AL

HR

KS

ME

MK

SLO

SRB

&

+385 1 2911470

[email protected]

Eastern Mediterranean,

Middle East - Africa

Area Sales Office:

&

+357 22 465200

[email protected]om

IR

OM

UAE YEM

&

+971 4 3318070

grohedubai@grome.com

Far East Area Sales Office:

&

+65 6311 3600

[email protected]

GROHE 19592000 Installation guide

GROHE 19592000 Installation guide

in other languages

Related papers

Other documents