Whirlpool WVES 23932 IX Program Chart

Brand: Whirlpool

Model: WVES 23932 IX

Type: Program Chart

This manual is also suitable for

Whirlpool WVES 23932 IX is a feature-rich freezer that offers flexible storage options, energy-saving modes, and advanced temperature control to keep your frozen foods fresh and well-preserved. With its spacious freezing compartment, you can easily store large quantities of food. The adjustable temperature settings, ranging from -16°C to -24°C, allow you to customize the freezing conditions based on your needs.

1. Control panel

2. Ice packs (inside - if provided for)

3. Rating plate (at side of drawer)

4. Freezing compartment

5. Zone for drawers and pull-out baskets

Storage zone

Freezing zone

Note: The design of drawers and

accessories may vary, depending

on the model.

DE GB IT FIDKNOPTESNLFR SEGR

A. 6th Sense. “6th Sense” activation indicator

(See enclosed instructions)

B. On/Standby. Standby button. Press for at

least 3 seconds to activate it. Press the icon

once to reactivate the keypad.

C. Temperature. Set temperature indicator.

D. Temperature. Temperature setting button.

E. Key Lock. Key Lock activated indicator.

Press for at least 3 seconds to activate/

deactivate the Key Lock. When activated,

pressing the other icons activates an audible

signal.

F. Stop alarm. Press in case of alarm.

G. Black-out alarm. Long Black-out

Alarm indicator. (See the section “alarm

signalling”).

H. Fast Freeze Fast Freeze on indicator. Press

to activate/deactivate the Fast Freeze

function. The Fast Freeze function switches

off automatically after 48 hours.

CONTROL PANEL

PRODUCT SHEET

Freezer inside temperature adjustment

The appliance is normally factory-set for operation at the recommended temperature of -18°C.

The inside temperature setting can be adjusted between -16°C and -24°C, proceeding as follows:

• Press the inside temperature adjustment button D. The storage temperature can be changed by

-1°C with each press of the button: the value flashes cyclically between -16°C and -24°C.

• The“6thSense”functionisactivatedautomaticallyincaseofopeningofdoorsandtheintroduction

of small amounts of food to be frozen. Its duration is variable and depends on the product load

conditions and the outside temperature. It does not require any intervention by the user and

switches off automatically when normal operating conditions are restored

This optional function can be used to save energy.

To activate the Eco mode, press the buttons E and H together for 3 seconds until an audible signal

sounds.

Two seconds after activation of the Eco mode, the display goes off, except the 6th Sense icon

(and the audible signal is deactivated, if on).

To adjust the temperature or use other functions, it is necessary to activate the display by pressing

any button.

After about 15 seconds without performing any action, the display goes off again and only the 6th

Sense icon remains visible.

To deactivate this function, press the buttons E and H together for 3 seconds until an audible

signal sounds. The normal display is restored.

The Eco mode is automatically disabled after a power failure or a fault alarm.

Remember that this function does not disconnect the appliance from the power supply.

ECO MODE

DE GB IT FIDKNOPTESNLFR SEGR

Note: The temperature alarm may even be activated following prolonged opening of the door

or after fresh food products have been placed in the freezing zone; the temporary increase in

temperature signalled does not affect the perfect preservation of already frozen food.

ALARM SIGNALLING

Signal Cause Cure

Door open alarm The audible alarm is

activated.

The door has remained

open for more than 2

minutes

Close the door

Temperature

alarm

The audible alarm

is activated, the set

temperature flashes and

the red light F remains

The inside temperature

is not adequate

Press the button F; the

audible alarm stops,

the set temperature

flashes and the red light

F remains on until a

temperature < -10°C is

reached.

Long black-out

alarm

The audible alarm is

activated, the light G

remains on, the light F

flashes and the displays

shows the maximum

temperature reached.

Prolonged power

failure, able to cause the

inside temperature to

increase to 0°C

Press the button F; the

audible alarm stops,

the set temperature

flashes and the red light

F remains on until a

temperature < -10°C is

reached.

Malfunction The message “FF”

flashes on the display C

Product malfunction Contact the After-Sales

Service

1. Put the product in standby mode by pressing the button B for

at least 3 seconds.

2. Unplug the appliance or turn off the main switch.

3. Insert the chute (contained in the accessories bag) in the

special slot (see figure).

4. Follow the instructions given in the instruction booklet.

5. Reinsert the plug or turn on the main switch.

6. Reactivate the product by pressing the button B once.

5019 300 01142 Printed in Italy 03/12 - Whirlpool

DEFROST

DE GB IT FIDKNOPTESNLFR SEGR

Whirlpool WVES 23932 IX Program Chart

Brand: Whirlpool

Model: WVES 23932 IX

Type: Program Chart

This manual is also suitable for

Download PDF

report

Whirlpool WVES 23932 IX Program Chart

This manual is also suitable for

Whirlpool WVES 23932 IX Program Chart

Related papers

Other documents