CB 60 2C (FAN) ele
GB
5019 637 33008
Printed in Italy 03/01Printed in Italy 06/01
I
GB
D F NL E P GR
DK
S N FIN
CONTROL PANEL
1.
Refrigerator compartment “ON” button
2.
Green LED indicating refrigerator
compartment operation
3.
Refrigerator compartment temperature
selection buttons
3a.
Display indicating selected refrigerator
temperature
4.
Freezer compartment “ON” button
5.
Green LED indicating freezer
compartment operation
6.
Freezer compartment temperature
selection buttons
6a.
Display indicating selected freezer
temperature
7.
Fast freeze button
8.
Fast freeze indicator LED (yellow)
9.
Red LED alarm for indicating critical
temperatures within the freezer. (See
chapter “How to operate the freezer
compartment”)
10.
Freezer temperature acoustic alarm
muting button
Refrigerator compartment internal temperature control
The temperature is factory set at +5°C (display
3a
). To change the temperature setting:
Press the button
(3)
until the display shows the desired value
(3a)
.
Temperature selection limit: from +2 °C coldest temperature
to +8 °C warmest temperature
Freezer compartment internal temperature control
The temperature is factory set at -19°C (display
6a
). To change the temperature setting:
Press the button
(6)
until the display shows the desired value
(6a)
.
Temperature selection limit: from
EC
least cold temperature
to -24 °C coldest temperature
Note:
The ambient air temperature, the frequency of door opening and the position of the appliance can affect the internal
temperatures of the refrigerator. These factors must be taken into account when setting the thermostat.
Fan:
The fan gives more even temperature distribution inside the refrigerator compartment, thus allowing better
conservation of stored food.
Important:
The fan is activated by means of an electronic control. The control automatically activates the fan when it is
necessary.
DO NOT obstruct the fan intake area (12a) with food.
ENERGY SAVING
(“Blank Display” function
)
Declared performance on the LABEL includes this function. To enable this function, press button 10 (for at least
five seconds) until the Display becomes blank; it will switch on again (for 1 minute) whenever the door is opened
or a button is pressed. To disable the function, press button 10 again until the acoustic signal sounds. If an alarm
is activated, the function will be disabled automatically.
Replacing bulbs:
This product uses a special bulb; to replace do not unscrew. Pull towards the inside of the appliance.
6gb33008.fm5 Page 2 Friday, June 1, 2001 4:39 PM