Wingz Table
™
Installation Instructions
Page 2 © Zovuna
Parts
Slot cover (if option selected)
Non-slip pad (if option selected)
Wingz Table assembly
1/8" Hex Wrench
Page 3 © Zovuna
Installation Steps
1
Check arm width of your chair or
sofa to determine the
configuration needed.
If width is between 1 & 2.5 inches
go to step 2a.
If width is between 3 & 7 inches go
to step 2b.
2a
If the chair arm width is between 1 & 2.5
inches you will need to reconfigure the
adjustable arm. This is done by removing
the screws and reversing the adjustable
arm as shown.
2b
If the chair arm width is between 3 & 7
inches the standard configuration can be
used. Loosen screws so that adjustable
arm moves easily.
3
Slide table down on chair arm and move
adjustable arm so that it’s snug to chair
arm. Then tighten screws.
4a
If using the slot cover it should be pressed
into slot. Both ends should click into
place.
Note: Slot cover may not fit in cases where
screws are positioned near end of counter
sunk slot. There must be clearance on
both ends of the slot to use the slot cover.
4b
If using the non-slip pad simply place on
table while aligning the protruding bar on
the pad to the slot on the table. This will
align is perfectly with the table.
Page 4 © Zovuna
Hints and Tricks:
1. Non-slip indoor rug pad can be used between the table and the chair arm to keep the table in
place if needed.
2. Wingz table can be mounted backwards, extending inward, to support a tablet or laptop for
easy access.
3. Lint may show on the dark colored non-slip pads. This can be easily cleaned by removal of the
pad and placing under running water while lightly scrubbing. Dry between folded lint free
towel.
4. The non-slip pad is fabricated of a soft silicon rubber which may show some wear marks with
use on close inspection. This is normal and does not detract from the functionality of the
product. Replacement pads are available.
Need more help?
We hope that you enjoy your new Wingz Table. If you have questions please check the support
page at zovuna.com for any updates. Also do not hesitate to contact us at [email protected] if you
need more help.
Designed and assembled in the USA from parts sourced in USA and China.
Printed in the USA
Rev. 20170502
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Cisco Systems DOC-7812945= User manual
-
-
Rifton R830 User manual
-
QMS PS 410 User manual
-
Sunrise Medical Pulse 6SC Owner's manual
-
Invacare Rea Dahlia 45 User manual
-
Convaid Cruiser User manual
-
Sunrise Medical Q500 H Owner's manual
-
Motorola VSWR Service Manual Supplement
-
