© Danfoss | DCS (mrb) | 2019.06
AU308671508172
1
AK-SM 800 Digital Unloader
Programming
Programming Guide
1. Under Configuration for Suction Group, set Inverter Control to ‘VO’. Ensure min. speed and
startup speed are programmed to 30.0.
danfoss.us
© Danfoss | DCS (mrb) | 2019.06
AU308671508172
2
2. Under Addresses screens, assign variable output as ‘Comp Inv’, ensure type is 0-5V.
For on/off inputs, assign virtual points (i.e. 99-1.1, 99-1.2).
3. Under status screen for suction group, go to ‘Service’ tab and manually override proof
and fault (proof to Manual On, fault to Manual Off).
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alternations can be made without subsequential changes being necessary in specications already agreed.
All trademarks in this material are property of the respecitve companies. Danfoss and Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
-
1
-
2
Danfoss 080Z4006 User guide
- Type
- User guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Danfoss 080Z4006 User guide
-
-
-
Danfoss 084B8032 User guide
-
-
-
-
-
-
Danfoss 120H1446 Installation guide