Page is loading ...
TOP VIEW
LNB ARM/ASTRA1 ASTRA3
Diseqc (V1.0/V2.0)
Command 1 or A Command 2 or B
INSTALLATION
• Place, when viewing from the top, the LNB with the left feedhorn in the
LNB arm.
• Connect the coaxial cables to the 1, 2 or 4 outputs (depending on
model)
• Set the Diseqc positions in the receiver (Command 1 or A for Astra 1,
Command 2 or B for Astra 3)
• Because the signal of Astra 3 is weaker then Astra 1 it is better to
optimize the reception on Astra 3. Then Astra 1 reception will be ne.
• Turn the LNB with the Astra 3 feed a little upwards until the maximum
signal strength.
• The LNB works best with a 80 cm dish, and is also suitable for 60 cm
dishes.
1
Safety precautions:
To reduce risk of electric shock, this
product should ONLY be opened by an
authorized technician when service is
required. Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or moisture.
Warranty:
No guarantee or liability can be accepted for any changes and modications
of the product or damage caused due to incorrect use of this product.
General:
Designs and specications are subject to change without notice.
All logos brands and product names are trademarks or registered
trademarks of their respective holders and are hereby recognized as
such.
Attention:
This product is marked with this symbol. It means that used
electrical and electronic products should not be mixed with
general household waste.
There is a separate collections system for these products.
Copyright ©
2
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
/
