Metra 98-9003 Installation guide

APPLICATIONS

METRA. The World’s best kits.

™

metraonline.com1-800-221-0932

REV. 4/7/2014 INST98-9000

CAUTION: Metra recommends disconnecting the

negative battery terminal before beginning any

installation. All accessories, switches, and especially

air bag indicator lights must be plugged in before

reconnecting the battery or cycling the ignition.

NOTE: Refer to the instructions included with the

aftermarket radio.

INSTALLATION INSTRUCTIONS FOR PART 98-9000

•Intendedforusewithasingle-DINradioinstalledintoa

 varietyofMetradashkits.

•Pocketandtablet/phonemountconnecttogetherfora

 solidmountinfrontoftheaftermarketradio.

•Willchargetheconnecteddevicethroughmount.

•3.5mmaudioinputjackonfrontofpocket.

•98-9000foriPadmini(1stgen)

•98-9001foriPhone4and4s

•98-9002foriPhone5

•98-9003forSamsungS3,S4,Note1,andNote2.

See metra-online.com for specific

vehicle applications

•A)Pocket•B)Tablet/phonemount•C)ATCfuseholder(notshown)•D)5-ampATCfuse(notshown)

KIT FEATURES

KIT COMPONENTS

•Panelremovaltool•Phillipsscrewdriver

•Socketwrench

TOOLS REQUIRED

Pocket and tablet/phone mount

98-9000

A

B

2

1. Installthepocketalongwitha

singleDINradiointotheMetra

installationkit.(FigureA,B)

2. ConnectRCAtoanAUXinputon

aftermarketradio.

3. Theredandblackwiresfromthe

pocketareforchargingthrough

thepocket.Connecttheblackwire

toground.Connecttheredwireto

afused12-voltaccessorypower

source.Afuseandfuseholder

havebeensuppliedinthiskitfor

the12-voltpowerwire.

Kit Assembly

(Figure A) (Figure B)

98-9000

3

Kit Assembly 98-9000

 Continued on next page

iPad mini (first Gen)

Front

Back

Finger Push-out Window

To push out iPad mini from the case

Open Base Port

Volume - Volume +

IR Lens

Audio Pin

Plugs into ipad’s

audio jack

Mounting Arm

Connects to 98-9000

Open Base Port

Hold the key to insert or

release iPad mini

Red Switch

To Lock and Unlock

from the 98-9000

Power on/off button

Turn iPad mini on or off

Kit Assembly 98-9000

4

(Figure A) (Figure C)

(Figure B)

1. Pushtoclosethe”Openkey”

(FigureA)

2. InsertiPadminiintothecasewith

thechargeconnectorportmatched

withthecase’s“OpenPort”

position,thenpushiPadminidown

intothecase.(FigureB)

3. WhentheiPadminiisinsidethe

case,slidetheiPadminitothe

left,thenpressthe“Openkey”to

ensuretheiPadminiisheldfirmly

bythecase.(FigureC).

 Continued on next page

Installing iPad mini (first Gen) into the case

Kit Assembly 98-9000

(Figure A) (Figure C)

(Figure B)

5

1. SlightlyslidetheiPadminitowards

thedirectionofthe”Openkey”

(FigureA)

Note: to prevent damge of

locking parts, please do not pull

the “Open key” too hard when

removing the iPad mini from

the case.

2. Useyourindexfingertopush

upontheiPadminithroughthis

circularhole.(FigureB)

3. TakeouttheiPadminifromthe

casefollowingthedirection

indicated.(FigureC)

Removing iPad mini (first Gen) from the case

Kit Assembly 98-9000

6

1. Pushthebuttonontherightsideofthevehicledock

toraisetheActivitieslock.

2. InserttheiPhone/Samsungintothesocketofthe

VehicleDockadapter,atthesametime,lowerthe

Activitieslocktosecurethephone.

Continued on next page

Installing iPhone/Samsung on the Vehicle Dock

Step 1

Step 2

Kit Assembly 98-9000

Installing tablet/phone mount into pocket

7

1. Whileholdingthe“grayswitch”

totheUNLOCKposition,slidethe

tablet/phonemountintothepocket

asshowninthediagrams.

2. Whenthetablet/phonemount

isfullyinsertedintothepocket,

releasethe“grayswitch”to

LOCKposition.

3. Adjustthetiltangletothe

desiredposition.

4. Toremovethemount,holdthegray

switchtotheUNLOCKposition.

Gray

Lock

Button

FullLock-InpositionFirstLock-Inposition

METRA. The World’s best kits.

™

metraonline.com1-800-221-0932

REV. 4/7/2014 INST98-9000

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certified technicians

INSTALLATION INSTRUCTIONS FOR PART 98-9000

Page is loading ...

INSTRUCCIONES DE INSTALACIÓN PARA LA PIEZA 98-9000

METRA. The World’s best kits.

™

metraonline.com1-800-221-0932

REV. 4/7/2014 INST98-9000

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recomienda técnicos

con certificación del Programa

de Certificación en Electrónica

Móvil (Mobile Electronics

Certification Program, MECP).

EL CONOCIMIENTO ES PODER

Mejoresushabilidadesdeinstalaciónyfabricación

inscribiéndoseenlaescueladedispositivoselectrónicos

móvilesmásreconocidayrespetadadenuestraindustria.

Regístreseenwww.installerinstitute.comollameal

800-354-6782paraobtenermásinformaciónyavance

haciaunfuturomejor.

Metra 98-9003 Installation guide

This manual is also suitable for

Metra 98-9003 Installation guide

in other languages

Related papers

Other documents