2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Metra
  7. 98-9001

Metra 98-9001, 98-9000, 98-9002, 98-9003 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Metra 98-9001 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
APPLICATIONS
METRA. The World’s best kits.
™
metraonline.com1-800-221-0932
© COPYRIGHT 2014 METRA ELECTRONICS CORPORATION
REV. 4/7/2014 INST98-9000
CAUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
INSTALLATION INSTRUCTIONS FOR PART 98-9000
•Intendedforusewithasingle-DINradioinstalledintoa
varietyofMetradashkits.
•Pocketandtablet/phonemountconnecttogetherfora
solidmountinfrontoftheaftermarketradio.
•Willchargetheconnecteddevicethroughmount.
•3.5mmaudioinputjackonfrontofpocket.
•98-9000foriPadmini(1stgen)
•98-9001foriPhone4and4s
•98-9002foriPhone5
•98-9003forSamsungS3,S4,Note1,andNote2.
See metra-online.com for specific
vehicle applications
•A)Pocket•B)Tablet/phonemount•C)ATCfuseholder(notshown)•D)5-ampATCfuse(notshown)
KIT FEATURES
KIT COMPONENTS
•Panelremovaltool•Phillipsscrewdriver
•Socketwrench
TOOLS REQUIRED
Pocket and tablet/phone mount
98-9000
A
B
2
1. Installthepocketalongwitha
singleDINradiointotheMetra
installationkit.(FigureA,B)
2. ConnectRCAtoanAUXinputon
aftermarketradio.
3. Theredandblackwiresfromthe
pocketareforchargingthrough
thepocket.Connecttheblackwire
toground.Connecttheredwireto
afused12-voltaccessorypower
source.Afuseandfuseholder
havebeensuppliedinthiskitfor
the12-voltpowerwire.
Kit Assembly
(Figure A) (Figure B)
98-9000
3
Kit Assembly 98-9000
Continued on next page
iPad mini (first Gen)
Front
Back
Finger Push-out Window
To push out iPad mini from the case
Open Base Port
Volume - Volume +
IR Lens
Audio Pin
Plugs into ipad’s
audio jack
Mounting Arm
Connects to 98-9000
Open Base Port
Hold the key to insert or
release iPad mini
Red Switch
To Lock and Unlock
from the 98-9000
Power on/off button
Turn iPad mini on or off
Kit Assembly 98-9000
4
(Figure A) (Figure C)
(Figure B)
1. Pushtoclosethe”Openkey”
(FigureA)
2. InsertiPadminiintothecasewith
thechargeconnectorportmatched
withthecase’s“OpenPort”
position,thenpushiPadminidown
intothecase.(FigureB)
3. WhentheiPadminiisinsidethe
case,slidetheiPadminitothe
left,thenpressthe“Openkey”to
ensuretheiPadminiisheldfirmly
bythecase.(FigureC).
Continued on next page
Installing iPad mini (first Gen) into the case
Kit Assembly 98-9000
(Figure A) (Figure C)
(Figure B)
5
1. SlightlyslidetheiPadminitowards
thedirectionofthe”Openkey”
(FigureA)
Note: to prevent damge of
locking parts, please do not pull
the “Open key” too hard when
removing the iPad mini from
the case.
2. Useyourindexfingertopush
upontheiPadminithroughthis
circularhole.(FigureB)
3. TakeouttheiPadminifromthe
casefollowingthedirection
indicated.(FigureC)
Removing iPad mini (first Gen) from the case
Kit Assembly 98-9000
6
1. Pushthebuttonontherightsideofthevehicledock
toraisetheActivitieslock.
2. InserttheiPhone/Samsungintothesocketofthe
VehicleDockadapter,atthesametime,lowerthe
Activitieslocktosecurethephone.
Continued on next page
Installing iPhone/Samsung on the Vehicle Dock
Step 1
Step 2
Kit Assembly 98-9000
Installing tablet/phone mount into pocket
7
1. Whileholdingthe“grayswitch”
totheUNLOCKposition,slidethe
tablet/phonemountintothepocket
asshowninthediagrams.
2. Whenthetablet/phonemount
isfullyinsertedintothepocket,
releasethe“grayswitch”to
LOCKposition.
3. Adjustthetiltangletothe
desiredposition.
4. Toremovethemount,holdthegray
switchtotheUNLOCKposition.
Gray
Lock
Button
FullLock-InpositionFirstLock-Inposition
METRA. The World’s best kits.
™
metraonline.com1-800-221-0932
© COPYRIGHT 2014 METRA ELECTRONICS CORPORATION
REV. 4/7/2014 INST98-9000
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
INSTALLATION INSTRUCTIONS FOR PART 98-9000
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
INSTRUCCIONES DE INSTALACIÓN PARA LA PIEZA 98-9000
METRA. The World’s best kits.
™
metraonline.com1-800-221-0932
© COPYRIGHT 2014 METRA ELECTRONICS CORPORATION
REV. 4/7/2014 INST98-9000
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recomienda técnicos
con certificación del Programa
de Certificación en Electrónica
Móvil (Mobile Electronics
Certification Program, MECP).
EL CONOCIMIENTO ES PODER
Mejoresushabilidadesdeinstalaciónyfabricación
inscribiéndoseenlaescueladedispositivoselectrónicos
móvilesmásreconocidayrespetadadenuestraindustria.
Regístreseenwww.installerinstitute.comollameal
800-354-6782paraobtenermásinformaciónyavance
haciaunfuturomejor.
/