2. Hewlett Packard Enterprise
  3. G-Series LTE Sensor
G-Series LTE Sensor

Hewlett Packard Enterprise G-Series LTE Sensor Installation guide

  • Hello! I've reviewed the user guide for the Aruba Sensor. This document provides instructions on connecting the sensor via Ethernet, mounting options using brackets and adhesive, what the status light colors indicate and troubleshooting steps if connectivity issues arise. I am ready to help answer your questions about the sensor setup and usage.
  • What ports does the sensor need access to?
    What do the status light colors indicate?
    What if the status lights are a color other than green?
Let’s Set Up Your Sensor
1x sensor
If one of these colors persists for several minutes, please
restart the setup process with the sensor plugged into an
unrestricted Ethernet port. For additional help with sensor
installation, go to sensor.arubanetworks.com/install.
Package Contents
Status lights will blink green
when ready to configure.
Please take note if status lights
are one of the following colors:
This sensor requires an Ethernet connection. Make sure
the sensor can connect to the Internet through access on
port 80 and port 443.
Ethernet + optional AC power supply
1. Wait for status lights to blink green.
sensor.arubanetworks.com/start
sensor.arubanetworks.com/install
Use supplied screws and anchors to mount the bracket to
any surface. Slide the sensor onto the bracket after
connecting the Ethernet cable. If adhesive mounting is used,
the sensor must be mounted below 6.5ft (2m) in height.
See sensor.arubanetworks.com/install for additional
mounting instructions.
/