B-PSEBH READER
INSTALLATION
INSTRUCTIONS
B-PSEBH READER INSTALLATION INSTRUCTIONS
CAUTION /WARNING
FCC OVERVIEW
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, you can try to correct the interference by taking one or more of the following measures.
q Reorient or relocate the receiving antenna.
q Increase the separation between the equipment and receiver.
q Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
q Consult the dealer or an experienced radio/TV technician for help.
THIS DEVICE COMPLIES WITH INDUSTRY CANADA LICENCE-EXEMPT RSS STANDARD(S).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept
any interference, including any interference that may cause undesired operation of the device. This Class [B] digital apparatus meets all
requirements of the Canadian Interference-Causing Equipment Regulations.
CET APPAREIL EST CONFORME À LA NORME RSS INDUSTRIE CANADA EXEMPT DE LICENCE.
Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d’interférences et (2) cet
appareil doit accepter toute interférence, y compris les interferences pouvant causer un mauvais fonctionnement du dispositif. Cet
appareil numérique de la classe [B] respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.
1. Orient the new reader assembly and insert the reader
cable through the slot in the outside escutcheon.
2. Position the reader assembly on the reader gasket and
install the four reader assembly mounting screws.
BEST is a trademark of dormakaba USA Inc. ©2020 All rights reserved. T92181
CAUTION: Before you handle the electronics board or
any component connected to it, make sure that you are
properly grounded using an electrostatic discharge (ESD)
protection kit! Touching the board without proper ground-
ing can damage sensitive electronics components—even if
you don’t notice any static discharge!
CAUTION: Please keep the B-PSEBH Reader antenna
20cm away from people to ensure that RF exposure compli-
ance requirements are not exceeded.
WARNING: Changes or modifications not expressly
approved by dormakaba could void the user’s authority to
operate the equipment.
1
RCI 910TC-WRM Installation guide
NextCentury RR4 Installation guide
Brady BCENSYS-1000 User manual
Dynex DX-CR212 Quick setup guide
Datalogic PowerScan 9600 Series Owner's manual
Paxton ins-20006 Operating instructions
BIO RAD DTE41027 User manual
Develco Products H6500113 Installation guide