2. CURT
  3. 23079
23079

CURT 23079, 51438, 51439 User manual

  • Hello, I'm your chat assistant. I've reviewed the installation instructions for the CURT brake control harnesses 51438 and 51439. This document details how to connect the harness in Dodge Ram trucks, specifically the 1500, 2500, and 3500 models, and also how to test the connection. I am ready to answer questions about the installation process or any other aspect of the document.
  • Where is the vehicle brake control harness connector located?
    What should I do after installing the harness?
    What is the first step of installation?
Gas
Brake
E-brake
BH8
INSTALLATION INSTRUCTIONS
BRAKE CONTROL HARNESS
51438 & 51439 APPLICATIONS
Scan for helpful
installation tips
NOTICE
All steps must be followed to ensure the CURT brake control
harness will function properly. Once installed, test for proper
function by following the brake control unit instruction manual.
Make Model
Dodge Ram 1500
Dodge Ram 2500
Dodge Ram 3500
BH8 - Under dash, to right of emergency brake pedal
Representative vehicle shown below
LOCATION GUIDE
PAGE 1 • RA • NEED ASSISTANCE? • 1.877.287.8634 • CURTMFG.COM
A B
INSTALLATION /
SAFETY INSTRUCTIONS
Step 1
Locate the 4-pin, vehicle brake control harness connector under
the dash, to the right of the emergency brake pedal. It will be
taped to another harness. The connector will be similar to that
on the CURT brake control harness (A).
Step 2
Insert the connector on the CURT brake control harness into
the vehicle connector. Make sure the connector is fully inserted
with locking tabs in place (B).
Step 3
Insert the brake control harness's black connector into the
brake control's quick plug connector. Secure the brake control
harness with the provided cable ties, avoiding any pinch points.
Step 4
Complete the installation using the brake control instructions.
Mount the unit as directed and perform test procedures as
instructed in the brake control user manual.
CURTMFG.COM • NEED ASSISTANCE? • 1.877.287.8634 • RA • PAGE 2
/