CURT 51446 User manual

Brand: CURT

Model: 51446

Type: User manual

This manual is also suitable for

51447

Below you will find brief information for 51446, 51447. This document provides installation instructions for the CURT brake control harness, specifically for Dodge Durango and Jeep Grand Cherokee vehicles equipped with a factory tow package. The harness connects to the vehicle's brake control connector, found under the dash and to the brake control unit. It provides connection between vehicle and brake control. The provided figures show the location of the vehicle connector and the steps to connect the harness.

Below you will find brief information for 51446, 51447. This document provides installation instructions for the CURT brake control harness, specifically for Dodge Durango and Jeep Grand Cherokee vehicles equipped with a factory tow package. The harness connects to the vehicle's brake control connector, found under the dash and to the brake control unit. It provides connection between vehicle and brake control. The provided figures show the location of the vehicle connector and the steps to connect the harness.

Gas

Brake

E-brake

BH8

INSTALLATION INSTRUCTIONS

BRAKE CONTROL HARNESS

51446 & 51447 APPLICATIONS

Scan for helpful

installation tips

NOTICE

All steps must be followed to ensure the CURT brake control

harness will function properly. Once installed, test for proper

function by following the brake control unit instruction manual.

Make Model

Dodge Durango (w/ factor y tow package)

Jeep Grand Cherokee (w/ factory tow package)

BH8 - Under dash, to right of emergency brake pedal

Representative vehicle shown below

LOCATION GUIDE

PAGE 1 • RA • NEED ASSISTANCE? • 1.877.287.8634 • CURTMFG.COM

A B

INSTALLATION /

SAFETY INSTRUCTIONS

Step 1

Locate the felt liner under the dash, to the left of the steering

column. Remove the two plastic fasteners securing the liner (A).

Behind the felt liner, locate the vehicle brake control harness

connector. It will be attached to the top of a junction box (B).

The connector will be similar to that on the CURT brake control

harness.

Step 2

Insert the connector on the CURT brake control harness into

the vehicle connector. Make sure the connector is fully inserted

with locking tabs in place.

Step 3

Insert the brake control harness's black connector into the

brake control's quick plug connector. Secure the brake control

harness with the provided cable ties, avoiding any pinch points.

Step 4

Complete the installation using the brake control instructions.

Mount the unit as directed and perform test procedures as

instructed in the brake control user manual.

CURTMFG.COM • NEED ASSISTANCE? • 1.877.287.8634 • RA • PAGE 2

1
2

CURT 51446 User manual

Brand: CURT

Model: 51446

Type: User manual

This manual is also suitable for

51447

Below you will find brief information for 51446, 51447. This document provides installation instructions for the CURT brake control harness, specifically for Dodge Durango and Jeep Grand Cherokee vehicles equipped with a factory tow package. The harness connects to the vehicle's brake control connector, found under the dash and to the brake control unit. It provides connection between vehicle and brake control. The provided figures show the location of the vehicle connector and the steps to connect the harness.

Download PDF

Related papers

Other documents