D6396-2
86124-1
LAMP
RESPONSE
WIND 45S
WIND 30P
WIND 30P
WIND 30P
WIND 30P
N.B. Refer to section 1.5 of the
ST7002 Operating Guide for full details
Use disp to adjust lighting level.
Wait 10 sec to return to previous mode.
Use or to adjust response level.
Press disp to return to previous mode.
1 sec1 sec
Auto Tack
STARBOARD
Auto Tack
PORT
Wind
Wind
Wind
WIND
Autopilot response controls course-keeping accuracy.
Higher response settings keep a tighter course but
increase the amount of drive activity and battery use.
Set to a level appropriate for your needs
To Automatically Steer
to a Fixed Wind Angle
Autotack
To Adjust Autopilot
Course-keeping Accuracy
Quick Start Guide
SmartPilot
®
ST7002 Controller
To Adjust Lighting Level
mode
®
STANDBY
AUTO
AUTO
AUTO
AUTO
TRACK
STARBOARD
AUTO
STANDBY
NEXT WPT
55˚
85˚
mode
mo
d
e
D6397-2
Display Layout
To activate the Autopilot For Manual Control
To change the
Autopilot Heading
To follow a Route
set on a Chartplotter
resp
Press to display
response level
auto
Press to activate
the Autopilot
standby + auto
Press for Wind Vane mode
res'm
Press to resume
previous course
track
When the Autopilot is activated,
press to folow a route from a
connected navigation system.
Press again to accept the
new course
course change keys
Port 1˚ Starboard 1˚
Port 10˚ Starboard 10˚
disp
Press to display
data pages
Press for 1 second
for lamp control
Press for 3 seconds
for power off
x3x3
OK?OK?
&
Press to adjust calibration,
response and gain
standby
Press for Manual Control
mode
Press to select
Wind Vane mode
-
1
-
2
Raymarine Marine Instruments D6396-2 User manual
- Type
- User manual
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Raymarine SmartPilot SPX-10 Setup Manual
-
-
-
-
-
-
-
-
-
Other documents
-
Raytheon ST6000 Plus Specification
-
Simrad MARINE COMPUTER - INSTALLATION REV A Owner's manual
-
-
NORTHSTAR Pilot System NS3300 User manual
-
-
-
-
-