Juno SDU1130B User manual

Brand: Juno

Model: SDU1130B

Type: User manual

Montage- und Gebrauchsanweisung

für den Dunstabzug

Instruction on mounting and use of the cooker hood

JDU 1450

JDU 1230

JDU 1130

SDU 1130

Abb. 1 - Fig. 1

Abb. 2 - Fig. 2

Abb. 3 - Fig. 3

Abb. 4 - Fig. 4

Abb. 5 - Fig. 5

Öffnen

Open

Abb. 6 - Fig. 6

Abb. 7 - Fig. 7

E14

40W max

Abb. 8 - Fig. 8

Use

The hood may be used as follows:

Exhausting version

The appliance is fitted with 2 exhaust outlets:

one at the top A and the other at the back B

(Fig. 1).

To connect the pipe fit the coupling ring C in

the outlet selected.

Use cover D to close the unused outlet

(Fig. 1).

Remove the exhausting grid (Fig. 2).

Lever E: in position G (Fig. 3).

Refit the exhausting grid.

Choosing the exhausting pipe

The coupling ring C has a diameter of

120mm.

We suggest to use Ø 120 mm exhausting

pipe.

Recycling version

The air is purified by means of a charcoal

filter and recycled into the room through the

front grid.

Remove the exhausting grid (Fig. 2).

Lever E: in position F (Fig. 4).

Refit the exhausting grid.

Mounting the circular charcoal filter

(Fig. 5):

a. Position the circular charcoal filter so

that it covers the plastic grate which

protects the fan wheel and motor.

b. Check that the small tab (1) coincides

with the arrow (2) printed on the conveyor.

c. Turn in clockwise direction.

Installation

When installed, the hood must be not less

than 60 cm. above electric burners or 70

cm. above gas or mixed-fuel burners.

Warning!

— The hood cannot be connected to flues of

other appliances that run on energy

sources other than electricity.

— When the hood is used at the same time

of other appliances that run on energy

sources other than electricity, provision

must be made for an adequate supply of

air.

—No food must be cooked flambé

underneath the hood.

The use of an unprotected flame is

dangerous for the filters and could cause

fires.

Therefore, never use an open flame under

the hood. When frying foods, never leave

the pan alone because the cooking oil

could flare up.

— Please, keep to the provisions of official

directives regarding the question of fume

discharge.

— The manufacturers refuse to accept any

responsibility for damage to the hood or

its catching on fire because of failure to

observe the above instructions.

Suggestions for the installation and

use of the hood

— The horizontal sections of the pipe must

be slanted slightly upwards (about 10%)

to ensure an easy flow of the air outwards.

— The best performance of the unit is

obtained in the exhausting version,

therefore in the limits of the possibilities

it is advised to use this version.

— The best performances are obtained with

short pipes (max. 4 m) and with few

curves.

Electric connection

Before completing any connection, make

sure the house voltage corresponds with

the voltage indicated on the label affixed

inside the hood.

The hood is supplied with a standard plug;

connect it to a correspondingly standard

socket.

In the case is intended to connect the

appliance permanently to the mains after

having removed the plug supplied, must be

fitted a two-pole switch conforming to

regulations with an opening distance

between contacts of not less than 3mm.

The manufacturers are not liable for any

problems caused by the user’s failure to

observe the above instructions.

Fixing to the cabinet - Fig. 6

a. Make four holes at the bottom of the

cabinet .

b. Remove the exhausting grid (Fig. 2).

c. Remove the screws from the container

on the side of the conveyor.

d. Fit the four 4.2x35 screws supplied, from

inside the cabinet in the holes on the

appliance.

e. Refit the exhaust grid.

Using the hood

JDU 1230 - JDU 1450

The hood is provided with a 3-speed motor.

For the best performance, we recommend

using the low speeds in normal conditions

and the high speeds in particular cases of

strong odour and vapour concentration.

JDU 1130 - SDU 1130

The hood is provided with a 1-speed motor.

— We recommend starting up the hood a

few minutes before cooking and keeping

it running until all the odours have been

eliminated.

Maintenance

Before performing any maintenance

operation, disconnect the hood from the

electricity.

Grease filter

The hoods JDU 1230, JDU 1130 and SDU

1130 have a thin paper grease filter; the

hood JDU 1450 has a metal grease filter.

The metal grease filter lasts forever and

must be washed at least once a month

either by hand or in the dishwasher (60°C)

with suitable detergents.

Attention! When washed in a dishwasher,

the metal grease filter may discolour.

Let the filter dry without damaging it before

putting it back into place.

This paper grease filter must be replaced

every month.

To replace the filter, proceed as follows:

a. Slide the two side latches to release the

grid (Fig. 2,2 - Fig. 2,3).

b. Remove the grid completely , pull the

right side of the grid forward and unhook

it from the slots to which it is attached

(Fig. 2,5).

c. Remove the stops of the filter (Fig. 7,1 -

Fig. 7,2).

When the filters are washed, the grid should

also be cleaned with warm water and

biodegradable detergent.

Charcoal filter

This filter dissolves cooking odours.

The charcoal filter must never be washed.

It should be changed every 4 months in

normal use.

Mounting and replacing the charcoal

filter:

a. Disconnect the hood from the electricity.

b. Remove the exhausting grid (Fig. 2).

c. Pull-out the tab (1).

d. Turn the filter in the counterclockwise

direction (2).

To mount a new charcoal filter, see the

section in the paragraph Recycling

version - Mounting the circular

charcoal filter

e. Refit the exhaust grid.

Replacing the lamp

a. Disconnect the hood from the electricity.

b. Remove the exhaust grid (Fig. 2).

c. Always replace burnt-out lamps with

40Watt max. (E14).

d. Fit again the exhaust grid.

e. Before calling for repair service because

the hood fails to light up, make sure the

bulbs are screwed in tightly.

Cleaning

To clean the outside of the hood use a cloth

moistened with denatured alcohol or neutral

liquid detergents.

Never use products containing abrasive.

Attention

Failure to observe the rules for cleaning the

appliance and changing and cleaning the

filters may cause fires.

Therefore, we recommend observing these

instructions.

LI08MA

ELECTROLUX - ZANUSSI HAUSGERÄTE GMBH

Rennbahnstraße 72-74

D-60528 Frankfurt

Juno SDU1130B User manual

Juno SDU1130B User manual

Related papers

Other documents