ESAB JS 200 Powder storage cabinet User manual

Brand: ESAB

Model: JS 200 Powder storage cabinet

Type: User manual

JS-200 - Powder Storage Cabinet

1 (2) www.esab.com

Use

The unit is intended for storing welding powder in the temperature range 100-300

C. The unit is to

be used only in accordance with these instructions. Is must not be used for any other purpose

because of possible injuries or material damage.

Before use

Check the unit for transport damages; do not connect a faulty unit to the mains. Check that the

voltage and frequency marked on the rating plate match the values of the mains to which the unit is

to be connected. Place the silo firmly and evenly on the support provided. The lid, attached to the

support for the duration of the transport, in place on top of the silo. Place the silo with its emptying

chute downwards in such a position that the control box is against the indentation. Screw the

earthing cable in the control box to the support using the screw attached to the support.

Location

To avoid overheating, the clearance to any material must be no less than 0,5 m on any side and no

less than 1 m above the unit. Make sure that there are no obstacles and no flammable material closer

to the unit. The unit must never be covered. Place the unit in a dry place on a flat surface. The

enclosure class of the silo is IP 20, it must not be subject to dripping or splashing water. The unit

may not be used in environments where there is danger of explosion (EX).

Using the unit

Connect the unit to the mains. Set the thermostat at the desired temperature. The red pilot light is lit

whenever the unit is connected to the mains. Pour the welding powder to be stored into the silo from

above. The upper level of the powder must not be above the upper end of the air circulation tubes

inside the silo. Select the temperature recommended by the manufacturer of the powder. The lid

must be slightly ajar when the silo is on. This is achieved by setting the support lever of the lid

against the rim of the silo.

Other matters to be considered

When pouring fine powder into and out of the silo, the powder may cause dust. A dust respirator

filter should be worn when handling the powder. Extreme care should be exercised when

pouring powder from the dryer, as it may be very hot, depending on the temperature chosen,

and may cause burns if handled carelessly.

Remove the plug from the wall socket whenever the silo is not in use.

JS-200 - Powder Storage Cabinet

2 (2) www.esab.com

Specification

Voltage 230 V 50 Hz

Power 2000 W

Storage temperature 100 - 300

Capacity approx. 200 litres

Dimensions W*D*H 510*570*1750 mm

Weight approx. 110 kg

Equipment thermostat, thermometer, pilot light

ESAB AB Made by: Ergi Oy

SE – 695 81 Laxå Finland

Phone: +46 584 81000 phone: +358-9-753 8005

Fax: +46 584 13056 fax: +358-9-753 8460

ESAB JS 200 Powder storage cabinet User manual

ESAB JS 200 Powder storage cabinet User manual

ESAB JS 200 Powder storage cabinet User manual

Related papers

Other documents