Intertherm S5BXM Installation guide

Brand: Intertherm

Model: S5BXM

Type: Installation guide

Intertherm S5BXM, a reliable and efficient gas furnace, offers a range of features to enhance your home's comfort and energy efficiency. With its durable construction and advanced technology, this furnace delivers dependable heating performance for years to come. From its multi-speed blower for precise temperature control to its high-efficiency operation, the S5BXM ensures a consistently comfortable indoor climate while minimizing energy consumption. Experience the warmth and efficiency of the Intertherm S5BXM in your home.

Addendum to Export Unit Installation Instructions

Split Systems & All Packaged Equipment

This addendum is applicable to all units manufactured for export-only and intended for use with

R-22 refrigerant. As of January 1st, 2010, all equipment manufactured of this conﬁguration will

be shipped with a Nitrogen holding charge in compliance with U.S. Code of Federal Regulations

(CFR) Title 40 part 82.

Customer orders may contain equipment manufactured in both 2009 and 2010. All units

manufactured prior to 1 Jan, 2010, have been factory charged with the amount and type of

refrigerant as shown on the unit rating plate. No actions should be necessary on these units.

ONLY units manufactured AFTER December 2009 will need to be charged

in the ﬁeld with R-22 refrigerant.

To determine if a unit will require a ﬁeld charge of R-22, inspect the unit rating plate and serial

#. The serial number is shown at the top of the unit rating plate and consists of a 12 digit code

with 5 parts.

Export Only Equipment

Any unit with a Year of Manufacture code in the unit serial # of 10 (or greater) and shows R-22

as the factory charged refrigerant, will require that the unit be charged with the procedure below

prior to operation.

WARNING: DO NOT operate any unit while it contains a Nitrogen holding charge. Doing

so may damage the units compressor.

To properly charge these units:

1) Read all Installation Instructions ﬁrst.

2) Complete any brazing operations. (e.g. Split system line-sets)

3) Purge the nitrogen holding charge.

4) Evacuate the unit to 350-500 microns.

5) Allow the unit to remain under vacuum for at least 30 min.

6) Weigh-In the proper amount of new (or reclaimed) R-22 refrigerant. Refer to the Unit Rating

Label or the unit installation instructions to determine the correct amount of charge.

XX P YY MM SSSSS

1st Two Digits = Unit Type Code

3rd Digit = Manufacturing Plant Code

Digits 4 & 5 = Year of Manufacture

Last Five Digits = Sequential Serial #

Digits 6 & 7 = Month of Manufacture

Example Serial #:

Installation Instructions

Speciﬁcations & illustrations subject to change

without notice or incurring obligations (10/13).

7091540 (NEW)

Intertherm S5BXM Installation guide

Intertherm S5BXM Installation guide

Intertherm S5BXM Installation guide

Related papers

Other documents