AM/FM 2 BAND DIGITAL DISPLAY
AM/FM 2 BAND DIGITAL DISPLAY
RADIO WITH DYNAMO FLASHLIGHT
RADIO WITH DYNAMO FLASHLIGHT
& LED READING LAMP
& LED READING LAMP
INSTRUCTION MANUAL
INSTRUCTION MANUAL
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
This symbol, located on back or bottom of the unit, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
This symbol, located on back or bottom of the unit, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
Any use of the controls or an adjustment to the procedures other than those specified herein may result in hazardous radiation.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). THERE ARE NO USER-SERVICEABLE PAR TS INSIDE. PLEASE REFER ANY SERVICING TO
QUALIFIED SERVICE PERSONNEL.
FCC Requirements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. however, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
inter ference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
When placing your unit on a lacquered or natural finish, protect your furniture with a cloth or other protective material.
WARNINGS AND PRECAUTIONS
Special Note
LOCATION OF FEATURES
CHARGING THE RECHARGEABLE BATTERY
DYNAMO POWER
AC ADAPTOR (NOT INCLUDED)
AUXILIARY BATTERIES (NOT INCLUDED)
SETTING THE TIME
LISTENING TO THE RADIO
SETTING THE ALARM TIME
WAKE TO RADIO OR ALARM CLOCK
USING THE FLASHLIGHT
EMERGING SIREN
REPLACING FLASHLIGHT-LANTERN BULB
REPLACING THE RECHARGEABLE BATTERY
USE LED READING LAMP
CARE AND MAINTENANCE
POWER DURATION
TROUBLESHOOTING GUIDE
TABLE OF CONTENTS
1
2
2
2
3
4
5
6
6
7
7
8
8
9
10
10
10
LOCATION OF FEATURES
- 1 -
21.
22.
23.
24.
25.
26.
HANDLE
EAR PHONE JACK
DC-IN JACK
DC-OUT JACK
BATTERY COMPARTMENT
DYNAMO CRANKING HANDLE
MINUTE SET BUTTON
RADIO/CLOCK BUTTON
POWER SOURCE SWITCH
BACK LIGHT BUTTON
VOLUME KNOB
TUNING KNOB
READING LAMP
MODE
BAND SWITCH
FM/WEATHER ANTENNA
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
FLASHLIGHT
FLASHLIGHT/SIREN/OFF SWITCH
ALARM
SPEAKER
LCD DISPLAY
TIME SET BUTTON
HOUR SET BUTTON
POWER INDICATOR
RECHARGE/BATTERY LOW INDICATOR
ALARM SET BUTTON
18
20
21
22
23
24
25
26
19
CHARGING THE RECHARGEABLE BATTERY
Note: Crank the dynamo
clockwise at a moderate
speed for about 3 minute.
This will provide a 1/5
charge.
You can also power an external
device such as a cell phone
(subject to device compatibility),
(Not Included), Connect the device
to the dynamo out jack and crank
the dynamo.
DYNAMO POWER
AC ADAPTOR (NOT INCLUDED)
Note: Keep the AC Adaptor
(Not Included) connected for
about 12 hours to fully charge.
- 2 -
DC 6V/200mA
AC OUTLET
AUXILIARY BATTERIES (NOT INCLUDED)
Replace the 3 "AA" batteries with new ones when the low battery indicator
illuminates or sound become unstable or cannot be heard or the clock display no
longer functions.
- 3 -
3 X "AA" Battries
for Back-up
RED
LED
SETTING THE TIME
- 4 -
Note: In the Radio on mode,
press the radio/clock
button to alternate
between radio and
clock displays.
Time set
1
2
3
LISTENING TO THE RADIO
RECHARGEABLE BAT T.=BUILT-IN NiCAD BATTERY
BATT.=3 "AA" ALKALINE BATTERIES (NOT INCLUDED)
LISTENING WITH HEADPHONES (NOT INCLUDED)
- 5 -
TO IMPROVE RECEPTION
FM
Volume
SETTING THE ALARM TIME
WAKE TO RADIO OR ALARM CLOCK
Note: Press the Alarm button once - the buzz sound will stop
for today and turn on the same time tomorrow. Press the
Alarm button twice - the Alarm indicator will disappear and
the alarm will not be heard tomorrow.
TURN TO THE
DESIRED
STATION
- 6 -
1
2 3
4
5
Volume
WAKE TO ALARM BUZZ
SETTING
SOUND
LEVEL
4
WAKE TO RADIO
USING THE FLASHLIGHT
EMERGENCY SIREN-FLASHING LIGHT
- 7 -
REPLACING FLASH LIGHT BULB
REPLACING THE RECHARGEABLE BATTERY
Unscrew the front cover. Remove the bulb by turning counter
clockwise. Replace the light bulb with 3.6V/0.3A.
(White LED optional)
- 8 -
Rechargeable
Battery Pad
3 X "AA" Batteries
for Back-up
USE LED READING LIGHT
- 9 -
LIFT UP TO TURN ON LED
READING LAMP
CARE AND MAINTENANCE
GENERAL
Use a soft, clean cloth moistened with plain, luke-warm water to clean the exterior of the unit.
Never use solvents such as benzene or other strong chemical cleaners since these could damage the unit's finish.
It is important that no liquid reaches the inside of the unit.
POWER DURATION
GENERAL
RADIO
FLASHLIGHT
BLINK/SIREN
10 days with new alkaline batteries/ 8 hours with fully
charged built-in NiCad battery.
1 day with new alkaline batteries/ 1 hour with fully
charged built-in NiCad battery.
2 days with new alkaline batteries/ 2 hours with fully
charged built-in NiCad battery.
TROUBLE SHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
SOLUTION
No sound is heard. Power is not on.
VOLUME Control is set to minimum.
Station has not been tuned properly.
FM reception is weak.
AM reception is weak.
Select appropriate power source.
Adjust the VOLUME Control.
Tune station properly.
Extend the FM antenna.
Adjust the position of the unit.
GENERAL
- 10 -
PMMU-0038-0105
/
