Please read and follow all manufacturers’ instructions for all tools and materials used. Provide adult supervision if children participate in this
project.
Disclaimer: The information found in each project is presented in good faith, but no warranty is given, nor results guaranteed, nor is freedom
from any patent to be inferred. Since we have no control over physical conditions surrounding the application of information herein contained,
Plaid Enterprises, Inc.disclaims any liability for untoward results.
Beginner Skill Level | 1 Hour Crafting Time
1. Make the pumpkin pendant: Begin with a large rectangle Podgeable shape. Trim fall
scrapbook paper to fit the top of the Podgeable shape. (You can use paper punches
too)
2. Apply a thin coat of Mod Podge to the top of the Podgeable shape and to the back of
the paper. Position the paper on the Podgeable. Smooth with your fingers. Apply a
top-coat of Mod Podge. Allow to dry 2 hours.
3. Cover the Podgeable with Dimensional Magic. Begin around the outer edge and fill
until the entire pendant is covered. Dry for 24 hours in an undisturbed and non-drafty
place.
4. Trim the fall paper to fit on the front of the glass candle. Apply Mod Podge to the back
of the paper and position on the candle. Smooth with your fingers to remove any air
bubbles. Allow to dry.
5. Tie a bow around the neck of the candle and attach the Podgeable with a jump-ring
or a piece of twine.
Tip: While the Dimensional Magic is drying don’t move the pendant around or you might
get air bubbles. If you do get an air bubble, use a sewing pin to pop it.