Raven RS1 Setup Manual

Manual No. 016-4010-007 Rev. A EC32799 02/19 1

Cellular Setup Guide - Raven RS1 with 2G/3G

Modem

SIM Card Installation

1. Visit the desired cellular service provider to purchase and activate a SIM card. RS1 2G/3G can support two

SIM cards if more than one cellular provider is required.

2. Remove the RS1 from the cab roof.

3. Locate and remove the SIM card access door on the bottom of the RS1.

Note: It may be necessary to remove the mounting plate to access the SIM card access door.

FIGURE 1. SIM Card Access Door

4. Insert a SIM card into the card slot.

Note: Note which slot the SIM card(s) was inserted in. This information is necessary for RS1

configuration later. The J11 slot corresponds to SIM card #1 in the Slingshot object pool. The J20

slot corresponds to SIM card #2 in the Slingshot object pool.

FIGURE 2. SIM Card Slots

5. Reinstall the access door and torque the screws to 6.5 to 7.5 in-lbs (0.73 to 0.85 N-m).

6. Reinstall the RS1 on the cab roof.

J11

J20

Raven RS1 Slingshot Activation

This quick guide provides the instructions to activate Slingshot on a Raven RS1. Activation occurs when the

machine is retailed and delivered to the end user. An RS1 connected to a Slingshot account is the only way to

transfer data, receive over the air updates, and get remote access in the cab.

Customer Information Required for Slingshot Activation

Complete the following information and email the form to ATDSlingshot[email protected]. It may take

as long as 24 hours Monday - Friday before activation occurs. Once the RS1 is activated, the email address

requesting the activation will receive an email confirmation.

FIGURE 3. RS1 Barcode Location

Barcode from Back of RS1:

Customer Requesting Activation:

Email Address:

Company Name:

Customer Phone Number: