MPN NO. : 215-448
SAP NO.:187000440
AS-18700-134
REV A, 2015/09/28
© 2015 Molex
http://www.molexpn.com/
MTS2016-0010
THIS INFORMATION IS CORRECT AS AT THE TIME OF PUBLICATION, SPECIFICATION ARE SUBJECT TO CHANGE SHEET No. 1 of 2
INSTALLATION INSTRUCTIONS
BEFORE INSTALLING OR ADJUSTING THIS PRODUCT,
PLEASE READ THESE INSTRUCTIONS CAREFULLY.
PLEASE KEEP THIS GUIDE FOR FUTURE REFERENCE
MIIM E-Module
1.0 SCOPE
This document provides installation instructions for the Molex IMD-00001 MIIM E-Module.
The following panels are compatible with the IMD-00001 E-Module:
PID-00266
PID-00271
PID-00268
PID-00272
PID-00269
PID-00273
PID-00270
PID-00274
2.0 PROCEDURE
IMPORTANT: Removing E-modules or MIIM continuity boards from the panel will result in loss of
continuity on all jacks in the panel. This is a service-affecting event and removal or replacement
procedures should be done off-hours or during a scheduled maintenance window. Continuity is
restored as soon as the E-module or continuity boards are inserted in the panel. Jacks do not have
to be removed when removing or adding E-modules.
Fig.1
Remove Continuity Boards
To remove MIIM continuity boards, pull the strap straight back on each of the four continuity boards
(See Fig. 1).
MIIM E-Module
SHEET No. 2 of 2
Fig. 2 Fig. 3
Install E-module in patch panel:
Install E-module in the slot below the contacts on the bezel (see Fig. 2). Rotate locking bar up
and insert E-module until contacts on the E-module are no longer visible (see Fig.3). Rotate
locking bar down to secure E-module. The locking bar should be in contact with the panel.
The E-module (or MIIM Continuity Boards) is required to maintain continuity on the permanent
link. FAILURE TO INSTALL THE E-MODULE WILL RESULT IN OPEN PAIRS.
Fig. 4 Fig. 5
Connect panel to scanner:
Connect MIIM panel to MIIM Scanner with a Category 5e or better patch cord (see Fig. 4). The
panel is powered by the scanner and will automatically turn on. Power is indicated by the Stat B
LED on the front of the panel.
Remove E-Module:
1. Lift locking bar up and rotate locking bar toward the front of the panel to disengage the E-module
from the panel (see Fig. 5).
2. Remove E-module.
3. Install replacement E-module or MIIM continuity boards.
LOCKING BAR
CONNECT
PATCH CORD
TO SCANNER
LOCKING BAR
SHOULD
CONTACT PANEL
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Emerson MVME3100 User manual
-
Xilinx Virtex-4 RocketIO User manual
-
Universal Devil Zone Installation, Operation, Maintenance And Service Manual
-
Broadcom BCM56780 Switch Programming User guide
-
Eurotech COM-1267 Owner's manual
-
-
KRAUS KBU23-KPF1612-KSD30CH User manual
-
-
Mettler Toledo EasySampler Operating instructions
-
NXP LPC2377FBD144 User guide
