2. Computers & electronics
  3. Networking
  4. Telephone switching equipment
  5. Patch panels
  6. Molex
  7. MIIM

Molex MIIM Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Molex MIIM Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
MPN NO. : 215-448
SAP NO.:187000440
AS-18700-134
REV A, 2015/09/28
© 2015 Molex
http://www.molexpn.com/
MTS2016-0010
THIS INFORMATION IS CORRECT AS AT THE TIME OF PUBLICATION, SPECIFICATION ARE SUBJECT TO CHANGE SHEET No. 1 of 2
INSTALLATION INSTRUCTIONS
BEFORE INSTALLING OR ADJUSTING THIS PRODUCT,
PLEASE READ THESE INSTRUCTIONS CAREFULLY.
PLEASE KEEP THIS GUIDE FOR FUTURE REFERENCE
MIIM E-Module
1.0 SCOPE
This document provides installation instructions for the Molex IMD-00001 MIIM E-Module.
The following panels are compatible with the IMD-00001 E-Module:
PID-00271
PID-00272
PID-00273
PID-00274
2.0 PROCEDURE
IMPORTANT: Removing E-modules or MIIM continuity boards from the panel will result in loss of
continuity on all jacks in the panel. This is a service-affecting event and removal or replacement
procedures should be done off-hours or during a scheduled maintenance window. Continuity is
restored as soon as the E-module or continuity boards are inserted in the panel. Jacks do not have
to be removed when removing or adding E-modules.
Fig.1
Remove Continuity Boards
To remove MIIM continuity boards, pull the strap straight back on each of the four continuity boards
(See Fig. 1).
MIIM E-Module
SHEET No. 2 of 2
Fig. 2 Fig. 3
Install E-module in patch panel:
Install E-module in the slot below the contacts on the bezel (see Fig. 2). Rotate locking bar up
and insert E-module until contacts on the E-module are no longer visible (see Fig.3). Rotate
locking bar down to secure E-module. The locking bar should be in contact with the panel.
The E-module (or MIIM Continuity Boards) is required to maintain continuity on the permanent
link. FAILURE TO INSTALL THE E-MODULE WILL RESULT IN OPEN PAIRS.
Fig. 4 Fig. 5
Connect panel to scanner:
Connect MIIM panel to MIIM Scanner with a Category 5e or better patch cord (see Fig. 4). The
panel is powered by the scanner and will automatically turn on. Power is indicated by the Stat B
LED on the front of the panel.
Remove E-Module:
1. Lift locking bar up and rotate locking bar toward the front of the panel to disengage the E-module
from the panel (see Fig. 5).
2. Remove E-module.
3. Install replacement E-module or MIIM continuity boards.
LOCKING BAR
CONNECT
PATCH CORD
TO SCANNER
LOCKING BAR
SHOULD
CONTACT PANEL
/