EASTMAN 48281 is a water heater connector that helps to prevent corrosion and leaks. It is compatible with both copper and iron pipes. The connector comes with two dielectric nipples, two compression adapters, two stainless steel connectors, and thread seal tape.

To install the connector, first turn off the electricity and water supply to the water heater. Then, apply thread seal tape to the dielectric nipples and install them into the top of the water heater. Next, screw the stainless steel connectors onto the dielectric nipples and tighten them with a wrench. Finally, install the compression adapters on the pipes and screw the loose ends of the stainless steel connectors onto the adapters.