CP-43BZ-LB Series

Gianni CP-43BZ-LB Series User manual

  • Hello! I have reviewed the instruction manual for the CP-43BZ-LB Series CP-43XBZ-LB Buzzer & Backlight Resettable Call Point. This document provides information about the device's installation, operation, and specifications, including its adjustable buzzer, LED indicators, and reset key. I'm ready to answer your questions about it.
  • What is the operating voltage of this device?
    What is the switch rating?
    What are the backlight color indications?
    Is the buzzer volume adjustable?
Three sets of signal output
Backlight illumination: Green (normal state), Red (activated)
Built-in buzzer: 80 dB (Volume adjustable, can be turned
off or set to intermittent)
CP-43XBZ-LB
&RS\ULJKW⯤$OOULJKWVUHVHUYHG308&3%=/%3XEOLVKHGRQ
LED
Volume
Buzzer
LED
ON Flash
ON DISC
NO COM NC
NO COM NC NO COM NC
Buzzer volume adjustment
Settings
Red LED continuous
Green LED continuous
Red LED flashing
(one second interval)
Green LED continuous
Red LED OFF
Green LED continuous
Volume
LED
ON Flash
Buzzer
ON DISC
Buzzer continuous
Buzzer beeps at one
second interval
Buzzer OFF
Activated
NO COM NC
NO COM NC NO COM NC
Alarm
Buzzer
Normal State
NO COM NC
NO COM NC NO COM NC
Press Here
Operating Voltage: 12/24VDC
Reset key included
Part Number:
Green G/Red R/White W
Yellow Y/Blue BL
Reset Key
Dimensions: 87x91x53 mm (with clear cover)
Contact Resistance: 100mΩ
Switch Rating: 3A 125VAC / 1.5A 250VAC
Plastic Case Color: Green / Red / White / Yellow / Blue
CP-43BZ-LB Series
Buzzer & Backlight Resettable Call Point
Instruction Manual
Unit:mm
(With clear cover)
Locked
Alarm
12 or 24 VDC IN
Buzzer
Locked Locked Locked
Reset Key
Power Supply
Electromagnetic
Lock
(Locked)
Alarm
Buzzer
Power Supply
Electric Strike
(Locked)
Power Supply
Alarm
Power Supply
Alarm
Electric Strike
(Unlocked)
Power Supply
Power Supply
Electromagnetic
Lock
(Unlocked)
Green: Normal State
Red: Activated
1
456
789
2 3
CP-43BZ-LB Series Mortise Mount
Take off the
plastic cover
and separate
the main body
from the base.
Use the reset key to split the main body
into two pieces.
Use a plier to
remove the
hooks of the
middle piece
as shown. Align the middle
piece and the
mounting box and
secure with two
screws.
Install the top
piece as shown
minding the
spring in the
middle.
Tighten the machine
screw to the hex nut.
The main body is now secured to the
mounting box.
Click the plastic
cover back back
on the front
side.
Close the plastic
cover lid with the
bottom secured
as shown. Installation complete.
Install the hex nut
on the middle piece
followed by the
spacer as shown.
Top piece Middle piece Complete as this:
Installation Instructions
Components
4
1
Reset key
Plastic top cover
Main body
5Self drilling screw x1
6Hex nut x1
7Hex nut spacer
3
Machine screw x1
2
Base piece
8
Recommend using 1 gang flush mount box conformed
to BS4662 (Not included)
(Not needed in this
installation method)
(mortise mount only)
(surface mount only)
&RS\ULJKW⯤$OOULJKWVUHVHUYHG308&3%=/%3XEOLVKHGRQ
/