Non-Keyed Sideplates

Emtek Non-Keyed Sideplates Installation guide

  • Hello! I've reviewed the installation guide for EMTEK Non-Keyed sideplates with Lever/Knob handles. This document provides step-by-step instructions on how to properly install your new hardware, including detailed information on door preparation, latch installation, and trim plate mounting. I am ready to assist with any questions you may have about the installation process.
  • What should I do before drilling holes?
    Which side should the privacy pin face for the privacy function?
    What is the purpose of the 'Edge Guide'?
    Can I use thru bolts on hollow doors?
Installation Guide - Non-Keyed Sideplates: Lever/Knob
IMPORTANT!: Lever/Knob location on the sideplate (Top, middle, bottom) varies depending on style.
Determine proper orientation BEFORE drilling holes.
IN4-NKEYPLTSLVRKNB REV. 1
11-08-2021
2. Door Prep 1. Determine Lever/Knob location & plate orientation
4. Install Inside Trim Plate
Edge
Guide
Provided
Plates and Lever/Knob vary depending on style
6. Tighten Lever/Knob
Optional Thru Bolts Privacy Function
3. Install latch
BOTTOM
OutsideInside
MIDDLE TOP
Prior to drilling holes, align side plate
using Edge Guide (provided).
For Privacy function:
Threaded hole for the
privacy pin must face
the interior side of the
door.
21
4"
2-3/8"
or
2-3/4"
1" Dia.
Edge Bores
2-1/8" Dia.
Bores
5. Install Outside Trim Plate
Thru bolts (provided)
may be used on hollow
doors instead of wood
screws (also provided).
Make sure the release
hole lines up with the
privacy pin.
After lock has been installed tighten
set screw with Allen Wrench.
Align Mounting
plate (sideplate not
shown for clarity)
1
2
3
Install Mounting Plate & Adjust for level
Install Sideplate
Dummy plate
3
1
2
1
3
/