IPOTEK SK569-WU-AC Wifi Smart Power Strip User manual

Type
User manual

The IPOTEK SK569-WU-AC Wifi Smart Power Strip lets you control three outlets and two USB ports independently, using an app or included remote control. You can set schedules and timers for connected devices, as well as group them and control them together. The power strip also features a countdown function and a low standby power consumption of less than 0.5W.

The IPOTEK SK569-WU-AC Wifi Smart Power Strip lets you control three outlets and two USB ports independently, using an app or included remote control. You can set schedules and timers for connected devices, as well as group them and control them together. The power strip also features a countdown function and a low standby power consumption of less than 0.5W.

Instruction Manual of SK569-WU-AC
Ver1.0
. Function
1. Product Feature
SK569-WU-AC is an American standard WiFi smart power strip ( 3 independently outlets +2
USB (Type A+C ) , which can be controlled by APP and remote. Equipped with remote
control function,count down function and timer function.
2. Product Picture
. Product Parameter
Appearance
Model#
SK569-WU-AC
Dimension
265**60*31MM (not contains the length of power
cord, 3ft power cord)
Product color
White
Product Weight
About 490g
Parameter
Input Voltage
125Vac/60Hz
Power Load
15A Max. 1875W resistive8A Max. 1000W
tungsten
USB
5V, 3.4A
WiFi Parameter
Support protocol: 802.11 b/g/nchannel:
Support safety mode: WPA/WPA2
Standby Power Consumption
0.5W
Mobile Phone System
iOS 8.0 and above
Android 4.4 and above
. Using Instruction
1. SK569-WU-AC is an American standard WiFi smart power strip ( 3 independently outlets
+2 USB A+C ). The main function is to control the on/off and set timing via APP. Before using
the device's functions, you need to pairing the WiFi firstly, namely, product can connect to
the Internet through WIFI, which can be a router or a mobile hotspot.
2. There is a button with indicator on the housing.
1) Click the button--turn on/off the power strip, the blue indicator light will light up when it is
on and off when it is off;
2) Long press-- enter into the EZ pairing mode, the indicator will flash quickly and then
connect to the network according to the EZ pairing steps.
3) Long press again when the indicator flash quickly and then enter into AP pairing mode.
When the indicator flash slowly, then connect to the network according to the AP pairing
mode.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

IPOTEK SK569-WU-AC Wifi Smart Power Strip User manual

Type
User manual

The IPOTEK SK569-WU-AC Wifi Smart Power Strip lets you control three outlets and two USB ports independently, using an app or included remote control. You can set schedules and timers for connected devices, as well as group them and control them together. The power strip also features a countdown function and a low standby power consumption of less than 0.5W.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI