2. Pal Electronics Systems
  3. VD900-433
VD900-433

Pal Electronics Systems VD900-433 Operating instructions

  • Hello! I'm a chat assistant and I have read the installation instructions for the PAL Vehicle Detector VD900-433. This document describes a wireless vehicle detector intended for use in parking lots and access control systems, with a battery that should last approximately 5 years with average use. I'm ready to answer your questions about the installation and features of this device.
  • What is included in the kit?
    How do I activate the detector?
    How long does the battery last?
----------------------------------------------------------------------------------------------------------------------
PAL Electronics Systems, HaTa'asiya 25 st, Ra'anana, Israel 4365413,POB 2516
Tel:972-9-7920667, Website: www.pal-es.com, Email: [email protected].(6)
Smart Vehicle Detector
VD900-433
INTRODUCTION
VD 900-433 series is a new wireless Vehicle
Detector featuring compact dimension,This
innovative detector is Plug and play, all-in-one
device that operates at a frequency range of
433MHz and is an ideal solution for vehicle
detecting when depart a public or office
parking.
It includes a web interfaces that makes it easy
to install and use.
The kit includes:
- Vehicle Detector
-433 MHz wired antenna
- startup magnet
Applications
•Parking lot management.
•Vehicle access control
Technical Specifications
Operating Frequency 433MHz ISM Band
Power Supply Battery DC 3.6 v
Dimensions 215mm ×125mm
Installation instruction link
Place the Vehicle detector at the center of rote
on a clean surface so it will be placed in center
path, so vehicles will pass when it is the vehicle
center as much as possible.
Vehicle Detector
Installation Instructions
Highlights
•Power provided by a buttery which will last for
approximately 5 years (1000 entrances per
day).
•Holds approximately 1000 kg weight
•
•WARNING: Not To Be Used for Personnel
Protection
----------------------------------------------------------------------------------------------------------------------
PAL Electronics Systems, HaTa'asiya 25 st, Ra'anana, Israel 4365413, POB 2516
Tel:972-9-7920667, Website: www.pal-es.com, Email: [email protected].(6)
Path center
Max 7m’
1
23
Preparations: Add the new detector to Pal SG304 –**WR
unit (receiver) with RF technology such: GI-WR, 4GI-L-
WR, GB-WR Pal access control units. Enter the
detector/s identification numbers.
To activate the detector, use the magnet provided
along with the detector. Put the magnet on the set-up
point and wait for 3 beep sounds slowly and a final long
sound. After the long sound remove the magnet at
least 1 meter from the detector.
Before installation
•Remove 4 screws from bottom cover
•Open the bottom cover
•Connect the jumper to it’s place.
•Close back the cover but very important to
place the seal back to its place.
/