Battery type: 371/SR920SW (Ø 9.5 mm x 2.05 mm)
Accuracy: +20/-10 seconds per month
1
3
4
INTERCHANGEABLE STRAPS
The included Stainless Steel Bracelet and Sweat Resistant Rubber Strap
both utilize quick release spring bars for seamless strap swaps.
Stainless Steel Bracelet
Rubber Strap (UV and sweat resistant)
Quick Release Spring Bars for Seamless Strap Swaps
CHANGING THE BEZEL
Twist and pull to remove the bezel. Replace by firmly
pressing new bezel onto the case.
Pull Up While Turning To Remove Bezel
Replace By Pressing New Bezel Down
1
2
3
4
5
5
2
LOCKED POS. (CROWN SCREWED IN) 200M WATER RESISTANCE - READY TO WEAR
UNLOCKED POS. (CROWN SCREWED OUT) NO WATER RESISTANCE
POS. I SETTING DATE & 24-HOUR DISPLAY (GMT HAND)
POS. II SETTING THE TIME
SETTING AM/PM (MIDNIGHT/NOON)
Unscrew and pull the crown to position I
Rotate clockwise to adjust the date and counter clockwise to
adjust the 24-hour display
Push the crown to Unlocked Position, then in one motion push
crown in and screw down to Locked Position
•
•
•
Unscrew and pull the crown to position II
Rotate clockwise until the current time is displayed
Push the crown to Unlocked Position, then in one motion push
crown in and screw down to Locked Position
•
•
•
When setting the time (POS II), rotate the hour hand past
12 o’clock and note the date window. If the date changes it is
midnight, if the date does not change it is noon.
Visit ridge.com/watchcare for more info.
45
SETTING THE TIME
RONDA POWERTECH
MOVEMENTS CALIBER 515.24H
This watch has been assembled with a genuine Swiss Ronda
movement from the Powertech family. It is extremely accurate
and rated within -10/+20 seconds per month.
Please note that it is extremely important to firmly screw the
crown down after setting the time in order to avoid water
damage and to retain the rated water resistance. Failure to
screw down the crown can result in water damage that will not
be covered under warranty.