1
2
3
4
5
1
2
3
4
5
Version: V1.0
31036504
6
5
1
2
3
4
7
8
9
10
5
1
2
3
4
6
7
8
9
10
Be sure to read and understand the information in the Safety
and Warranty Guide before using this product.
Note: Different computer models are shipped with different
items. Be sure that you have all of the components shown
above available for your computer.
Follow all installation instructions for your computer before
you turn it on and use it.
Note: Different computer models are shipped with different
items. Be sure that you have all of the components shown
above available for your computer.
Connect the power adapter to the computer and the
electrical outlet as shown above.
Ethernet connector
TV tuner
(Select models only)
USB ports (4)
Power button
Press the power button where is located on
the side of this computer to turn it on.
Adjust the computer display to your viewing preference.
The computer is
easy to fall over
and damage, if
the view angle is
over than 15°
backward.
The computer is easy
to fall over and damage
the screen, if the view
angle is over than 5°
forward and the glass
pieces might hurt
people.
Don't put your hand
on the joint of the
stand when you're
adjusting the
computer display
angle.
Computer instruction
Power button
USB ports (2)
Headphone
connector
Microphone
connector
Optical drive slot
Camera
Brightness down
touch button
Brightness up
touch button
LCD On/Off
Optical drive eject
touch button
Note: The buttons located on the bottom right of screen are touch button.
When you use your finger to touch them, the indicator will be light. But if you
touch the wrong button, the screen might be turn off. Then you need to turn
on the screen again.
To insert a disc, turn
the data side toward
the front of the
computer (label side
backward) and slide
the disc into the
drive slot.
To eject a disc,
make sure the
power is turned on
and then press the
eject touch button
on the bottom right
of the screen.
Don't insert 3 inch
optical disk into the
drive slot. Or the
disk might cannot be
ejected.
Important information about using this computer
Do not hold the stand and carry it upside down. Otherwise, it might damage the joint of the stand.
Hold the computer tightly when you carry it.
After installing the batteries, press the
keyboard power key.
Turn on the computer.
Press the Fn + F11 keys
on the keyboard to
establish the wireless
keyboard connection,
after about
5-10 sec-
onds.
Front view
Rear view
Open the battery compartment cover
Install 2 batteries in the
battery compartment.
LVT
connect
ON
OFF
Adjust the keyboard stand
to a comfortable level.
ON/OFF
Ajust the cursor
move speed
Wireless
Reset button
AA Battery
Battery
compartment
Turn on the mouse
power switch.
Turn off the mouse power switch when
you are not using it.
Press the wireless reset
button on the mouse.
Turn the mouse
to back
Turn on the computer. Press the Wireless Reset
button on the mouse to establish the wireless
mouse connection, after about 5-10 seconds.
Note:
If connection is not established successfully, repeat the same steps.
Notes:
1) In the process of establishing a connection, it is recom mended
to keep the distance between the keyboard, mouse, and computer
to less then 25 cm (10 inches).
2) The effective working distance of the wireless keyboard and mouse
is 1.5m (5 feet).
If the wireless device does not work, do the following:
1. Be sure there is no physical interference between the wireless
device and the computer.
2. Restart the computer, and verify the system devices are functional.
3. Repeat the procedure for establishing the Bluetooth connection.
4. Replace the batteries.
5. Do not place the computer under a metal surface or table.
6. Be sure that there are no high electromagnetic fields close by, such
as a speaker, other remote control, or cordless phone.
7. Do not place the keyboard, mouse and remote control in a
slanted, overturn or stand position.
8. Remove all batteries when you are not using the keyboard, mouse
and remote control for an extended period of time.
9. Clean the electrolyte, if there is leak from battery.
10. Be sure to use known, good batteries to ensure the remote works
properly and to avoid damaging the Remote Control.
11. The indicator light color of the keyboard power button is Orange
normally. It will become Red color when the power is low. You need
to change the battery at this moment.
Multimedia play key: Open the Mediaplay.
Internet key: Open IE.
E-Mail Key: Open the E-mail.
After starting the Windows operating
system, press the LVT key to start the
program. You can then learn to use this
featured software designed for the Lenovo
home PC with integrated Lenovo core
technology, and you can also use any other
installed programs on the computer.
Dormancy.
Stop.
Go to the previous track.
Play or pause.
Go to the next track.
Mute.
Volume Down.
Volume Up.
There are touch buttons and touch panel on the top right of
the keyboard. Use the touch panel similar with the common
mouse. The Touch buttons are as following:
Wireless Keyboard and Mouse instruction
Unpack and verify the
contents of the box.
e
Open
Power connector
Install 2
batteries in
the keyboard
battery com-
partment.
Close
LVT
e
d
ispla
y
y
t
t
o
o
y
y
o
o
u
u
r
r
v
v
i
i
e
e
w
w
i
i
n
n
g
g
p
p
r
r
e
e
f
f
e
e
r
r
e
e
n
n
c
c
e.
30
?
A
X
B
Y
NOTE:
Bluetooth LED bright (solid): Indicates that the connection is estab-
lished between the remote control and the computer.
M LED bright (solid): Indicates that CD game is active and can be
manipulated by the remote control.
3D LED bright (solid): Indicates that joystick game is active and can
be manipulated by the remote control.
Game switch button: Use to switch to the 3 different game modes --
preinstalled game, joystick game, or to turn off the game. Switch to
the different modes by pressing the button.
The remote control is the standard MCE remote control for the
model configured with Windows MCE.
The Wireless Phone and Air Mouse keys need to be pressed more
than 1 second to turn on or turn off these functions. You need to
install related software to use the Wireless Phone.
You can use the air mouse similar with common mouse to move the
cursor.
Note: Make sure the front side of the remote control always towards
up.
Under the air mouse and game mode, the remote control will go into the
standby status, when the remote control is inactivate for 10-20 seconds.
Under the standby status, the Bluetooth will keep connecting and
the indicator is light. You may move the remote control or press any
key to wake up the remote control and go back to the previous
mode.
Under wireless phone mode, the remote control will not go into the
standby status or sleep mode.
Under other mode, after the remote control going into the standby
status for 10 minutes and without waking it up. it will go into the
sleep mode. The Bluetooth will be disconnection and the indicator is
unlighted.
Press any key to wake up the remote control, but you have to wait
for several seconds to recover the Bluetooth connection.
You needn't to do the Bluetooth pairing again when it wakes up from
standby status or sleep mode.
When computer go into the standby status (S3), sleep mode (S4) or
turn off (S5), the remote control will go into the sleep mode auto-
matically and the Bluetooth will be disconnection. After waking up or
restarting the system, you may press any key on the remote control
to wake it up and finish the Bluetooth connection.
To save electric power of the battery, using the remote control
regularly.
When the remote control power indicator blinks every three seconds
interval, it indicates that the battery electric power is low and the
remote control will turn off automatically after 10 minutes.
The remote control cannot be used when the remote control power
indicator blinks three times in every second for three seconds and
with the beep sound at the same time. You need to change new
batteries to make it work.
Under Windows MCE mode:
MCE remote control works normally. You need press related button
to turn on the air mouse, game or wireless phone function.
Under Air Mouse mode:
MCE remote control and air mouse work normally. You need press
related button to turn on the game and wireless phone function.
Under Wireless Phone mode:
MCE remote control and wireless phone function work normally.
You need press related button to turn on the game and air mouse.
Under Game mode:
The Game function works normally. You need press related button
to turn on the air mouse, MCE remote control or wireless phone
function.
Bluetooth configuration
To install the batteries, press the cover in
and lift up.
Press the cover in and lift up.
Install the 3
batteries in the
battery compartment.
Note: If you experience a problem, verify
the batteries are good, and they are
correctly Installed. If not, the remote control
might not work or is possibly damaged.
The Remote Control initializes and is
now ready to be configured as follows.
Press Play and Digit 1
at the same time over
10 seconds.
When the Bluetooth LED indicator blinks twice con-
secutively at every second, and the remote control
makes beep sound, it indicates that the remote is
active and can be detected by the computer.
To proceed with the Bluetooth device configuration, do
the following as prompted.
Select the Lenovo_RC icon from the Name channels in
the Pair with wireless devices dialog box and click
Next. Select Creat a pairing code for me and the
password is 0000. The remote is now configured and
can be used.
Don't press Play and Digit 1, after successful
connecting the Bluetooth.
Bluetooth LED indicator will be on solid until
the successful completion of the Bluetooth
connection.
Bluetooth audio configuration.
To start the game, place the Game CD in the
optical drive and follow the prompts by
installing and using the remote. For more
information about the game, see the Access
Help on the Game CD.
Close
Air mouse
You can use the remote control as a regu-
lar mouse by using the air mouse.Under
the air mouse mode, all the functions of
remote control also can be used.
Air mouse buttons:
Left air mouse
button, Air mouse
On/Off button, Right
air mouse button.
When the air mouse
button is on, it indi-
cates the air mouse
is functional.
Press the air mouse On/Off button
until the key indicates that the air
mouse can be used normally.
Using the air mouse is the same as
using a regular mouse.
Be sure to hold the air mouse horizontally.
Do not use the air mouse in a slanted or
vertical position.
If you do, the result might not be your
intended selection.
Power
Record
Rewind
Replay
Back
Left air mouse/Game A
Volume up/Game X
Volume down/Game
throttle up
* key
Clear
Headphone
LED indicator of Bluetooth
LED indicator of joystick game
LED indicator of CD game
Game switch
Phone On/Off
Stop
Fast forward
Play or pause
Skip
Windows Media Center Start
More
Direction
OK
Air mouse ON/OFF
Right air mouse/Game B
Channel Up/Game Y
Mute
Channel down/Game throttle down
Guide
Digit/Input sources
# key
Enter
Teletex On/Off (Select models only)
Be sure to use known, good alkaline batteries to ensure the remote works properly and to avoid damaging the Remote Control. Remove all batteries when you are not using the Remote Control for an extended period of time. Use the remote as shown below:
Too close to the computer.
0 -1 meter (0 – 3 feet)
Suggested range:
1 - 3 meters (3 -10 feet)
Too far from the computer.
Over 3 meters (over 10 feet)
The optimum distance between the remote and
computer is 1 - 3 meters (3 -10 feet).
The best angle to use the remote is 30°.
Be sure there are no obstructions between
the remote control and the computer.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
Be sure the remote control wrist
strap is adjusted tightly on your
wrist when using the remote
control. This will prevent possibly
hitting a bystander, or other
objects in the area where you are
using the remote control.
Do not handle the
remote control if your
hand is wet or the
remote is wet.
You might receive an
electrical shock and or
damage the remote
control.
Be aware of both the
people and the objects
around you when you
use the remote.
To avoid hurting
someone or
damaging something,
do not attempt to
throw the remote
control.
To avoid hurting
someone or damaging
something, do not whirl
the remote control by
the wrist strap.
Keep a safe distance away from anyone using
the remote control.
Important information about using the Remote Control
1
OK
Press Game button to switch the game
to the preinstalled game mode.
OK
When the M LED is on, this indicates
the game has been switched to the
preinstalled game mode.
5
9
1
2
3
4
7
8
6
2
3
4
To switch to the Game mode
Turn on or turn off the Game mode, and switch all the games.
Turn on or turn off the Air Mouse mode.
Turn on or turn off the Wireless Phone mode.
Turn on the Windows Media Center
Note:
The direction key and OK key only can be used on Game mode, and they are useless
on the Windows Media Center mode.
In the Joystick Game mode, the Volume up and Volume down keys only can execute
Game X and Y, Throttle up and Throttle down functions.
In Windows, Click Start -> Control Panel to
open the control panel dialog box.
Select the Bluetooth icon in the dialog box
to add the remote device. Press Add
to open the Bluetooth device guide dialog
box. All the configuration process needs to
be finished within 180 seconds. Select the
related option in the pop-up Bluetooth
device dialog box and click Next.
Right click Lenovo_RC device and select
Property icon in the wireless device dialog box.
Select Headset icon from pop-up property
dialog box.
Right click Lenovo_RC device and select
Audio icon in the wireless device dialog box.
Click Connect icon if the Lenovo_RC audio
device is disconnection in Audio dialog box.
Microphone
ABC DEF
JKLGHI MNO
TUVPQRS WXYZ
*
＃
(Select models only )
-
1
-
2
Lenovo 30113RU - IdeaCentre A600 - 3011 Quick Reference Manual
- Type
- Quick Reference Manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Lenovo 10057/7712 User manual
-
Lenovo 08872CU User manual
-
Lenovo 40244CU User manual
-
-
-
-
-
-
-
