Traceable 1051 Owner's manual

Category
Alarm clocks
Type
Owner's manual
SPECIFICATIONS
Capacity: 23 Hours, 59 Minutes, 59 Seconds.
Resolution: 1/100th second (> 30 minutes)
1 second (< 30 minutes)
SINGLE ACTION TIMING
1. Press the MODE button until the unit displays the
stopwatchmode(indicatedbyaashingbarunderSU).
2. Press the LAP/SPLIT/RESET button to clear the display
to zero.
3.TherstpressoftheSTART/STOPbuttonstartsthe
stopwatchtiming.
4.ThesecondpressoftheSTART/STOPbuttonstopsthe
stopwatchtiming.(FlashingbarsunderFRandSA
indicatethattiminghasbeenstopped).
5.Afterthetimeisrecorded,presstheLAP/SPLIT/RESET
button to clear the display to zero. RESET will only clear
thedisplaytozeroafterthestopwatchhasbeenstopped.
TIME-IN/TIME-OUT TIMING
1. Press the MODE button until the unit displays the
stopwatchmode(indicatedbyaashingbarunderSU).
2. Press the LAP/SPLIT/RESET button to clear the display
to zero.
3.TherstpressoftheSTART/STOPbuttonstartsthe
stopwatchtiming.
4.ThesecondpressoftheSTART/STOPbuttonstopsthe
stopwatchtiming.(FlashingbarsunderFR,SA,andSU
indicatethattiminghasbeenstopped).
Thestopwatchwillholdthereadingwherestopped(Time-Out).
5.ThethirdpressoftheSTART/STOPbuttonstartsthe
stopwatch at the point that it was previously stopped
(Time-In).
AnynumberofTime-In/Time-Outintervalsmaybetaken.
6.Attheendofthetimingpress,theSTART/STOPbuttonto
stop the stopwatch, record the time, and then press the
LAP/SPLIT/RESET button to clear the display to zero.
RESET only clears the display to zero when the stopwatch
has been stopped.
LAP/SPLIT TIMING
Lap/splittimingfreezesthedisplayforpartialtimeswhilethe
internalclockcontinuestorunandmeasurethetotalelapsed
time.EachpressoftheLAP/SPLIT/RESETbuttoncaptures
thelap/splittimeordisplaysthecumulativerunningtime.
1. Press the MODE button until the unit displays the
stopwatchmode(indicatedbyaashingbarunderSU).
2. Press the LAP/SPLIT/RESET button to clear the display to
zero.
3.TherstpressoftheSTART/STOPbuttonstartsthe
stopwatchtiming.
4.TherstpressoftheLAP/SPLIT/RESETbutton“freezes”
thedisplayforrecordingatimewhiletheinternalclock
continuestorun.(TheblinkingbarsunderTH,SA,andSU
indicatetheinternalclockisrunning.)
5.ThesecondpressoftheLAP/SPLIT/RESETbutton
“releases”thedisplay.Thedisplayisinstantlyupdatedto
thecumulativerunningtime.
6.SuccessivepressesoftheLAP/SPLIT/RESETbuttonwill
“freeze”or“release”thedisplay.
Anynumberoflap/splitsmaybetaken.
7.Attheendofthelastevent,presstheSTART/STOPbutton
to stop the stopwatch and press the LAP/SPLIT/RESET
button to clear the display to zero. RESET only clears the
display to zero when the stopwatch has been stopped.
Whilethestopwatchisrunning,twofasttimescanbe
capturedbypressingtheLAP/SPLIT/RESETbuttonrstand
theSTART/STOPbuttonsecond.Theblinkingbarsunder
TH,SA,andSUindicatetheeventtimeisstoppedandthe
displayisshowingthe“frozen”lap/splittimeoftherstevent.
“Release”thedisplaybypressingtheLAP/SPLIT/RESET
buttonagain.TheblinkingbarsunderFR,SA,andSUindi-
catetheeventtimeisstoppedandthedisplayisshowingthe
cumulative total time. Press the LAP/SPLIT/RESET button to
clear the display to zero.
CONTINUOUS TIMING
Fortimingwhichlastsforover24hours,thestopwatch
instantly rolls over to zero when the maximum display is
reachedandcontinuestiming.Simplymakenoteofthedays
that have elapsed.
SETTING TIME-OF-DAY/DATE
1.PresstheMODEbuttonuntiltheunitdisplaystheclock
mode.
2.PressandholdtheMODEbuttonfor3seconds.Theunit
willdisplaythealarmtimewiththehourdigitsashing.
3.PresstheMODEbuttonagain.Theunitwilldisplaythe
time-of-daywiththesecondsashing.
4. Press the LAP/SPLIT/RESET button to set the seconds to
zero.(Ifthesecondsareabove30,thenpressing
LAP/SPLIT/RESET will reset the seconds to zero and
advance the minutes by one).
5.PresstheSTART/STOPbuttonandtheminuteswillash.
6. Press the LAP/SPLIT/RESET button to advance the
minutes.
Note:Pressingthebuttonasingletimewilladvancethedisplayby
one, press and hold the button to advance the display rapidly.
7. Repeat steps 5 and 6 to set hours, month, date, and day.
Note:Whensettinghours,anAorPtotherightthetimeindicates
AM/PM time.
8.Whennished,presstheMODEbuttontorecordthe
changesandreturntotheclockmode.
Todisplaythedate,whileintheclockmode,pressandhold
the START/STOP button.
Todisplaythetimein24-hourformat;whileintheclock
mode,whilepressingandholdingtheSTART/STOPbutton,
presstheMODEbutton.EachpressoftheMODEbuttonwill
togglethetime-of-daydisplayfromAM/PMto24-hourtime.
TRACEABLE
JUMBO-DIGIT
STOPWATCH
INSTRUCTIONS
®
SETTING TIME-OF-DAY ALARM
1.PresstheMODEbuttonuntiltheunitdisplaystheclockmode.
2.PressandholdtheMODEbuttonfor3seconds.Theunit
willdisplaythealarmtimewiththehourdigitsashing.
3. Press the LAP/SPLIT/RESET button to advance the hours.
4.PresstheSTART/STOPbutton.Theminuteswillash.
5. Press the LAP/SPLIT/RESET button to advance the
minutes.
6.PresstheMODEbuttontorecordthechangesandreturn
totheclockmode.
Todisplaythealarmtime,whileintheclockmode,pressand
hold the LAP/SPLIT/RESET button.
ACTIVATE/DE-ACTIVATE
TIME-OF-DAY ALARM AND HOURLY CHIME
Thetime-of-dayalarmandhourlychimemaybeactivatedin-
dependentlyofeachother.PresstheMODEbuttonuntilthe
unitdisplaystheclockmode.Whilepressingandholdingthe
LAP/SPLIT/RESETbutton,eachpressoftheSTART/STOP
buttonwilltogglethroughthefollowingsettings:
HourlyChimeActivated-
icon will appear on the display
Hourly Chime and Time-of-Day Alarm Activated-
and
)
)
)
icons will appear on the display
Time-of-Day Alarm Activated-
)
)
)
icon will appear on the display
Hourly Chime and Time-of-Day Alarm De-Activated-
No icons will appear on the display
Withthetime-of-dayalarmactivated,whenthealarmtimeis
reached,thealarmwillsoundforoneminuteandthenauto-
maticallyturnofftopreservethebatterylife.Asoundingalarm
maybeturnedoffbypressingtheLAP/SPLIT/RESETbutton.
With the hourly chime activated, a chime will sound at the top
ofeveryhour.
ALL OPERATIONAL DIFFICULTIES
Ifthisstopwatchdoesnotfunctionproperlyforanyreason,
replacethebatterywithanewhighqualitybattery(see
“BatteryReplacement”section).Lowbatterypowercan
occasionallycauseanynumberof“apparent”operational
difculties.Replacingthebatterywithanewfreshbatterywill
solvemostdifculties.
BATTERY REPLACEMENT
Afaintdisplay,incorrectdisplay,ornodisplayareallindica-
tors that the battery must be replaced. To replace the battery,
removethescrewsonthebackoftheunit.Removethe
back.Removethescrewonthebatteryclip.Removethe
exhaustedbatteryandreplaceitwithanew3-voltlithium
CR2032sizebattery.Makecertainthenewbatteryisin-
stalled with the positive side visible. Replace the battery clip
andtightenthescrew.Replacethebackoftheunit.Replace
thescrewsandtightensecurely.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
12554 Old Galveston Rd. Suite B230
Webster, Texas 77598 USA
Ph. 281 482-1714 • Fax 281 482-9448
www.traceable.com
Control Company is ISO 9001:2008 Quality-Certied
by DNV and ISO/IEC 17025:2005 accredited as a
Calibration Laboratory by A2LA.
Control Company Cat. No. 1051
Traceable
®
is a registered trademark of
Control Company.
©2016 Control Company. 92-1051-90 Rev. 4 052616
  • Page 1 1
  • Page 2 2

Traceable 1051 Owner's manual

Category
Alarm clocks
Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI